Celexon MultiCel LuxusLine OMG-1000 Manual De Instrucciones página 19

STEP 6: ADJUSTMENT/ALIGNMENT OF THE BRACKET
Back and forth
You can move the projector back and forth on the bracket on one axis. To do
this, loosen the adjusting screws and move the projector backwards or for-
wards along the guide rails. Then tighten the screws again.
A. Tilt correction (vertical)
Loosen the two lock nuts below the adjustment unit and turn the set screws
above to the set screws above to align the projector vertically. Both screws
can be adjusted independently to make any keystone corrections. The projec-
tor must only be adjusted horizontally or tilted downwards. If the projector is
tilted upwards, there is a risk that the threaded rod will be turned out of the
adjusting screw and the projector will fall out of the bracket and to the fl oor.
Then tighten the lock nuts again.
Adjusting screws for
Tilt correction
Adjusting screw
linear movement
Adjusting screw
linear movement
Settings
Inclination
8