Shark Ninja Detect Pro IW1000 Serie Guia Del Usuario página 28

AUTO-EMPTY ASSEMBLY (IW3000 SERIES)
1. Slide the Wand onto the neck of the Floor
Nozzle until it clicks into place.
2. Align the Hand Vacuum nozzle opening
with the top of the wand and slide it on
until it clicks into place.
3. Make sure the Dock is facing upright. Slide
the Charging Post into the slot on front of
dock until it clicks.
Handheld
Vacuum
2.
(Click)
Flex
Wand
Hand Vacuum
Storage Clip
1.
(Click)
Floor Nozzle
NOTE: Once the charging post is installed, it can't be removed.
54
s h a r kc l e a n . e u
4. Place the dock on the floor near a wall
outlet. Plug the Power Cord into the outlet,
then connect the cord to the port on the
back of the charging post.
5. Store the crevice tool accessory on the
mount on the dock.
6. Refer to pages 56 and 57 for Odour
Installation and Replacement instructions.
For proper operation, ensure all components
are completely connected and clicked
into place.
3.
Assembled
Dock
6.
Odour
Installation
4. Power Cord
5.
Accessory
Storage
NON-AUTO-EMPTY ASSEMBLY (IW1000 SERIES)
1. Slide the Wand onto the neck of the Floor
Nozzle until it clicks into place.
2. Align the Hand Vacuum nozzle opening
with the top of the wand and slide it on
until it clicks into place.
Handheld
Vacuum
2.
(Click)
Hand Vacuum
Storage Clip
1.
(Click)
For proper operation, ensure all components
are completely connected and clicked
into place.
Floor Nozzle
s h a r kc l e a n . e u
55