Shark Ninja Detect Pro IW1000 Serie Guia Del Usuario página 30

LI-ION BATTERY
Prior to first use, charge the battery completely. A full charge takes approximately 5 hours.
RUNTIMES PER FULLY CHARGED BATTERY
With a full charge, the unit will have up to a 60-minute runtime. Visit sharkclean.com/support
online for more information.
LED BATTERY POWER AND CHARGING INDICATORS
Charging
LED on the battery pack will pulse yellow when reaching 0-75% charge.
LED on the battery pack will pulse green from 75% - 100% charge.
White LED the battery pack is fully charged.
NOTE: Full charge takes approximately 5 hours.
Additional Notes
1. LEDs turn off once the battery is fully charged.
2. Unit will not power on when charger is connected.
In Use
Full Mid
Charge Charge
RECYCLING THE LI-ION BATTERY
When the Shark Li-ion battery needs to be replaced, dispose of it or recycle it in accordance
®
with local ordinances or regulations. In some areas, it is illegal to place spent lithium-ion
batteries in the standard rubbish bin. Return spent batteries to an authorised recycling centre
or to the retailer for recycling. Contact your local recycling centre for information on where to
drop off the spent battery.
NOTE: The Shark battery, like all lithium-ion batteries, will naturally decrease in capacity over time from the 100% capacity of
a new battery.
58
s h a r kc l e a n . e u
Low Nearly
Charge Empty
UPRIGHT DOCK CHARGING IW3000 SERIES
Charge the unit by placing it on the dock. Make
sure the contacts on the wand are aligned
with the contacts on the charging post.
When charging is complete and you need
to use the unit again, lift it off the dock.
No
Charge
IN HANDHELD VACUUM IW1000 SERIES
To charge the battery inside the handheld
vacuum, connect the charger to an electrical
outlet, then insert the charger plug into the port
below the handle on the handheld vacuum.
NOTE: When the unit is docked properly, the charging lights on the battery will blink, indicating that charging has begun.
NOTE: The main unit comes with a partial charge. For maximum runtime, charge fully before first use (approximately 5
hours). Leaving the unit plugged in will not damage battery life.
CHARGING YOUR LI-ION BATTERY
CHARGING WHILE IN STORAGE MODE
CONTACTS
HAND VACUUM RELEASE BUTTONS
To detach the hand vacuum from the wand,
press the front latch release button on the
hand vac where it meets the wand, then lift
off the hand vacuum. To reattach the hand
vacuum to the wand, align the hand vacuum
opening over the top of the wand and slide it
on until it clicks into place.
OUT OF THE VACUUM IW1000 SERIES
Press and hold the Battery Release Button,
then pull out the battery. Plug the charger
into the charging port on the battery. To
reinstall the battery, insert it into the slot in
the back of the handheld vacuum.
59
s h a r kc l e a n . e u