Shark Ninja Detect Pro IW1000 Serie Guia Del Usuario página 34

MAINTAINING YOUR VACUUM
CLEANING THE AUTO-EMPTY DOCK FILTER (IW3000 SERIES)
To access the filter in the dock, remove the Filter
Door. Press the button at the bottom of the door,
then tilt the door and lift it off. Remove the filter
from the dock. After the filter has been rinsed
and dried, reinstall it by reinserting it into the
dock and replacing the filter door.
For best results, clean your Auto-Empty filters at least once a month and replace the filters regularly. To clean filters, rinse with cold water
ONLY to prevent damage from cleaning chemicals. Allow all filters to air-dry for at least 24 hours before reinstalling them to prevent
liquid from being drawn into electrical parts. Maintaining your Exhaust Foam Filter will ensure successful Auto-Empty evacuation.
NOZZLE MAINTENANCE
POWERFIN FLOOR NOZZLE
1. Turn off the vacuum.
2. Press the nozzle release button to detach
the nozzle from the wand.
3. Press the brushroll release button and
slide the brushroll out of the nozzle.
4. Clear any blockages and remove any
debris from the brushroll and floor nozzle.
66
s h a r kc l e a n . e u
To access the the Auto-Empty Exhaust Foam
Filter, remove the dust bin. Before removing
the Exhaust Foam Filter, vacuum off any fine
debris from the surface. Lift the Exhaust
Foam Filter out of the dock, then rinse it with
water only (do not use soap). Allow the filter
to air-dry completely before reinstalling it.
5. Tap off loose debris and wipe the brushroll
clean with a dry towel. Hand wash the
brushroll if needed, using only water,
and then let it air dry completely for at
least 24 hours.
6. When the brushroll is dry, reinstall it into
the nozzle by inserting it into the nozzle
until it clicks.
MAINTAINING YOUR VACUUM
CLEANING THE SENSORS
Fig. 1
Air path
Dust cup
Battery
DIRT DETECT SENSORS
Fig. 2
CLEANING THE LIGHT REACT SENSOR
Make sure to clean the Detect sensors
regularly, as hair and other debris may build
up and obstruct them. If the sensors are
partially obstructed, Clean Sense Detect
mode will not function as expected.
To clean the sensors (Fig. 1):
1. Turn off power and remove the floor nozzle.
2. Locate the DirtDetect Sensor in the nozzle
of the hand vac (Fig. 1), the LightDetect
Sensor on the top of the nozzle (Fig. 2),
and the EdgeDetect sensor on the side of
the nozzle (Fig. 3).
3. Gently wipe the sensors with a microfibre
cloth and remove all hair and debris.
4. Reattach the floor nozzle to the rest of the
unit and turn on power. Verify that the unit
is functioning normally.
CLEANING THE EDGE DETECT SENSOR
s h a r kc l e a n . e u
67