Publicidad
Idiomas disponibles
Idiomas disponibles
EN
OPERATING AND MAINTENANCE MANUAL
OPERATION
Important information for the safe use of the plasma cutting torch and the operation of the interlocking
and safety devices.
Rating of electrical controls incorporated in the torch: 42VDC 0.5A.
Before using the torch, ensure that all the cables are in serviceable condition and that the connectors are
correctly fastened.
How to use the safety lever and torch trigger
Lever in safety position.
1
Released position of the safety lever.
2
Safety pin
The pilot arc can only be ignited when the torch consumables are installed correctly.
The safety pin forms two electrically connected safety contacts when the retaining cap is properly
installed.
Requirements for a plasma cutting power source to form a safe unit with the plasma cutting torch:
• As the plasma cutting nozzle (tip) cannot be protected from direct contact due to technical reasons, the
plasma cutting power source must conform to the standard EN 60974-7.
• The plasma cutting torch connected to / used with the plasma cutting power source must conform to the
standard EN 60974-10.
• The plasma cutting power source must conform also to the standard EN 60974-1.
• The plasma cutting power source and the plasma cutting torch must have the same ignition type (No HF
or HF) and the same rated current and required duty cycle.
10
All trademarks are the property of their respective owners. The information and images are indicative and may be subject to change at any time without notice. © 2022 Trafimet Group SpA
To start the arc ignition, press the trigger.
3
To stop cutting, release the trigger.
4
Publicidad
