Publicidad
Idiomas disponibles
Idiomas disponibles
EN
OPERATING AND MAINTENANCE MANUAL
OPERATION
Shielded consumables
Maintain light contact between the shield and the workpiece.
Move the torch at a constant speed. Do not press the torch too hard on the workpiece.
It is always recommended to use templates or cutting accessories for straight or circular plasma cutting.
Gouging
1
1
2
1
3
4
Consumable mounting sequence
12
All trademarks are the property of their respective owners. The information and images are indicative and may be subject to change at any time without notice. © 2022 Trafimet Group SpA
Place the torch at a 45˚ angle to the workpiece before starting gouging.
To start the pilot arc, press the torch trigger. Aim the arc to the workpiece.
45˚
45°
Keep the torch at a 45˚ angle to the workpiece during the whole operation.
The gouging direction remains the same to the end of the workpiece.
Gouging
direction
Publicidad
