Descargar Imprimir esta página

Trafimet PLUSCUT 85 Manual De Instrucciones Y Mantenimiento página 9

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 26
CONNECTIONS
Before connecting the
torch, switch off the
power source, disconnect
the power plug and
switch off the gas supply.
USE
Do not bend cables and
hoses in order to avoid
damages that may prevent
proper gas and coolant
circulation.
MAINTENANCE
Turn off the power
source before perfoming
torch maintenance.
Replacement of any
spare parts or other
maintenance must be
performed after the
torch has cooled down.
All trademarks are the property of their respective owners. The information and images are indicative and may be subject to change at any time without notice. © 2022 Trafimet Group SpA
Before connecting
the torch to the power
source, check the
correct electrical
connections
according to the
enclosed wiring
diagrams, where
applicable.
Do not use the torch
for purposes other than
plasma cutting/gouging/
marking.
Replace the tip when it
is worn (e.g. the hole
is enlarged or changed
from its original shape).
Replace the electrode
when it is worn (e.g. the pit
exceeds 1.2 mm).
Tighten the nozzle so
that parts are securely
fastened. Ensure the tip
does not turn easily.
Make sure that the
air pressure and flow
rate match the values
specified for the torch.
Compressed air must
be free of dirt, moisture
and oil.
Always use the original
Trafimet spare parts and
consumables.
Check the condition of
the cable and handle
periodically. Repairs
may be carried out by
qualified personnel only.
9

Publicidad

loading

Este manual también es adecuado para:

Pluscut 105