Publicidad
Idiomas disponibles
Idiomas disponibles
8. Remove belt from trimmer head pulley.
9. Note the position of the control cable
and idler return spring, then remove
idler assembly from chassis and re-
move belt and idler from trimmer.
10.Remove belt from idler assembly by
removing bottom belt keeper and idler
pulleys.
11
.Assemble
new belt, idler pulleys
and
bottom
belt keeper
to idler bracket.
Tighten
pulley
bolts
securely.
NOTE:
Be sure belt is inside
top belt
keeper
on idler assembly.
12. Position
belt and idler assembly
in
trimmer,
reconnect
idler spring
and as-
semble
idler to chassis.
13. Install
belt around
trimmer
head pulley
and engine
pulley.
NOTE:
Be sure belt is inside
belt keeper.
14. Replace
debris
shield
and tighten
the
four
(4) screws
securely.
15. Replace
chassis
cover
and tighten
screw
securely.
Always
use Craftsman
replacement
parts
to assure
proper
fit and long life.
I
I
I
I
L
Engine pulley
Belt
Nut
Idler assembly
Top belt keeper
Spacer
Idler
spring
Idler bracket
Spacer \
Flat idler
Bottom
belt
keeper
../_/
Flat idler
Trimmer head pulley
ENGINE
ENGINE
SPEED
Your engine
speed
has been factory
set.
Do not attempt
to increase
engine
speed
or it may
result
in personal
injury.
If you
believe
that the engine
is running
too fast
or too slow, take your
unit to a Sears or
other
qualified
service
center
for repair
and/or
adjustment.
CARBURETOR
Your carburetor
has a nonadjustable
fixed
main jet for mixture control.
If your engine
does not operate properly due to suspect-
ed carburetor
problems,
take your unit to
a Sears or other qualified service center
for repair and/or adjustment.
iMPORTANT:
Never tamper with the
engine governor, which is factory set for
proper engine speed.
Overspeeding
the engine above the factory high speed
setting can be dangerous.
If you think
the engine-governed
high speed needs
adjusting,
take your unit to a Sears or
other qualified service center, which has
proper equipment
and experience to make
any necessary adjustments.
14
Publicidad
