Publicidad
Idiomas disponibles
Idiomas disponibles
Readthese instructions and this manual
in its entirety before you attempt to as-
semble or operate your new trimmer.
IMPORTANT: This trimmer is shipped
WITHOUTOILORGASOLINEin the engine.
Your new trimmer has been assembled
at the factory with the exception of those
parts left unassembled for shipping
purposes. All parts such as nuts, wash-
ers, bolts, etc., necessaryto complete the
assembly havebeen placed in the parts
bag. Toensure safe and proper operation
of your trimmer, all parts and hardware
you assemble must be tightened securely.
Use the correct tools as necessaryto
ensure proper tightness.
When right hand (RH) or left hand (LH) is
mentioned in this manual, it meanswhen
you are in the operating position (stand-
ing behind the handle).
Loose Parts Packed Separately
Bottle of oil
Trimmer Lines (2) Sets
(0.155 diameter
x 18.75 inches long)
HandLe
\\
knob
Lower
handle
Upper handle
LIFT UP
INSTALL STARTER ROPE
1. Loosen T-knob.
2. Place throttle control in FAST position.
3. Slowly pull engine starter rope out until
rope will slip into loop of rope guide.
4. Tighten T-knob.
REMOVE
TRIMMER
FROM
CARTON
1.
Removeloosepartsindudedwithtrimmer.
2.
Cut down
two end corners
of carton
and lay end panel
down
flat.
3.
Remove
all packing
materials.
4.
Roll trimmer
out of carton
and check
car-
ton thoroughly
for additional
loose parts.
HOW
TO SET
UP YOUR
TRIMMER
TO UNFOLD
HANDLE
IMPORTANT:
Unfold
handle
carefully
so
as not to pinch
or damage
control
cables.
1.
Loosen
handle
knob
enough
to allow
upper
handle
to be unfolded
from the
shipping
position.
2.
Raise upper handle
section
into place on
lower
handle
and tighten
handle
knob.
3.
Remove
handle
padding
holding
trim-
mer head control
bar to upper
handle.
Your trimmer
handle
can be adjusted
for
your trimming
comfort.
Refer to "ADJUST
HANDLE"
in the Service
and Adjustments
section
of this manual.
6
Rope g
Engine
rope
Publicidad
