Publicidad
Idiomas disponibles
Idiomas disponibles
Before
assembly we recommend to
find the serial number and save
it. You can find this number,
referred to as "S/N" in a label
pasted on the outside of the motor housing.
You can write down this number in the
warranty document. It is mandatory to
provide the serial number to the Technical
Service for any intervention. See picture
06 on page 9
Where to install:
See picture 03 on page 5
• Make sure that the place where the fan
is going to be installed is quite wide, as
this will allow a better air flow
• Make sure that the fan blades do not
come into contact with any object,
minimum space of 0,6m on each side.
• Do not place the fan in an open space,
or in a room where there is moisture or
exposure to water.
• Make sure that the bracket for hanging
the fan to the ceiling or other suitable
structure is capable of supporting at
least 45Kg, with the two long fixing
screws included. Make sure that at
least 30 mm of the screw is screwed
into the bracket.
• If you want to install the product in a
suspended ceiling or drywall ceiling
make sure there is a beam available
with the right section that can bear 45
kg. If such beam is not available you
must install a 2"x4" cross brace support
between the ceiling beams that will act
as support.
• Only the fans with a support rod or bar
can be installed on sloping roofs where
the angle of inclination does not exceed
25º. This model cannot be installed on
sloping roofs.
Our fans are not designed to be
installed in plasterboard or
false ceiling, as these materials
may not support 45kg.
Note: Fastening screws (included) are
starting
with
the
designed for use with the fan and are
fastened to wooden beams or concrete
ceiling. If the installation is carried out
on a different material, it is advisable to
use the appropriate fixing screws for that
material (these screws are not supplied
with this equipment).
Step by step:
Here at UniversalBlue we have
created videos to explain the
assembling process. You can
find them in our YouTube
channel, by clicking on the
following link, or scanning this QR code.
Select the model you have purchased from
the list..
Youtube link:
playlist?list=PLWr7XjixBD4z5wryoYFEMFvDYKfkgIKlc
Or scan the QR code:
You can see the whole assembling
sequence in picture 04 on page 6.
Note: The images are for guidance only and
should be used to support the installation.
Fan body:
• Open the carton box and take the fan
out.
• Loosen the two screws located on the
top part of the fan body, where the
downrod is going to be inserted. Then
remove the safety pin from the downrod
and save it. Remove as well the screws
on the hemisphere on the top part of the
down rod and save them. Remember
that one of them will hold the earth
https://www.youtube.com/
EN
33
Publicidad
