Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
wire extension cable (pic. 1 and 2).
• Introduce the cables through the down
rod (pic. 3) Fit the rod in the motor
housing and insert again the safety
pin previously removed. Then, tighten
the screws of the motor housing which
have been loosened before (pic. 4)
• Follow this sequence: Insert the down
rod through: the bottom cover, the trim,
and the top cover and finish by placing
the rubber hemisphere (pic. 5)
• To fix the hemisphere again: Insert the
safety pin in the holes on the top part of
the down rod (pic. 5.1) Then bring up the
rubber hemisphere until all the holes
are aligned (pic. 5.2) Last, fix it with the
screws you have removed earlier and
fix the earth wire with one of them (pic
5.3)
• Once you have finished, adjust the
bottom cover and hide the connection
between the down rod and the motor
housing.
How to fix the receiver to the ceiling:
• Use a drill to make the holes on the
ceiling according to the fan size.
Assemble the bracket on the ceiling
using the appropriate screws. Make
sure it is well fixed.
• Warning: the screws supplied are
designed to be used on wooden beams
and concrete ceilings. (Pic. 6)
• You must loosen the two screws on the
bottom part so that the top cover can be
assembled.
How to assemble the blades:
• Take the screws out of the accessories
bag. Insert the blades in the slots and
align the three holes on the blades with
the three holes in the main structure
of the lamp. Fix and tighten using
the screws supplied. The blades are
designed to fit perfectly. The screws
must be vertical with respect to the
blade. Tighten evenly the screws to the
blades to prevent the fan from swinging
(pic. 7)
34
How to assemble the LED plate light:
• Remove the screws from the light
support (pic.8)
• Place the light plate so that the holes are
aligned with the holes for the screws
you have previously removed from the
light support (pic. 9)
• Connect the cable coming out from the
motor to the inlet located in the centre
of the LED plate light (pic. 10)
• Then fix the screws on the LED plate.
Please, make sure the lighting kit is
well fixed after you have tightened the
screws (pic. 11)
• Lastly, put the glass cover very carefully,
as it is a very fragile part. The cover will
be threaded to the light support. Make
the threads match the slight creases on
the support and turn it clockwise until
well fixed. Make sure it is well fixed,
otherwise it could fall and break (pic.
12)
Electrical connections:
• Put the fan on the ceiling bracket
by introducing the down rod in the
receiver bracket and turn it until you
hear a "click" sound, insert the slot
located on the hemisphere of the down
rod, in the tab of the receiver bracket.,
(pic. 13)
• Then we can proceed to do the
pertinent electrical connections. See
image sequences 04 on page 8 and 05
on page 9.
• First, connect the cables coming out
of the ceiling using the circuit board
located on the receiver support.
Connect the phase wire to L and the
neutral wire to N (pic. 14)
• Once you have made the connections,
place the receiver between the
bracket and the fan, with the smooth
part facing upwards. (pic. 15)
• Then connect the cables coming out
of the ceiling bracket and the fan
body to the cables coming out of the
receiver. Connect the earth wires
too. (pic.16)
• Last, slide the top cover up and align
Publicidad
