16
English
If the problem recurs more than once, contact the Authorised Service Centre.
(**) WI-TOUCH PAIRING MODE procedure (FIG.6)/PAGE 75: perform pairing if the WI-TOUCH function is not active and you have already tried
all the remedies listed in the TROUBLESHOOTING table above.
EN
1) Follow the installation sequence in fig. 2.
2) Insert the plug in the power socket
3) Set the starter device (H) on "ON/1 POWER UNIT WI-TOUCH" and press the WI-TOUCH trigger (N+I). The machine will start up in "1 POWER UNIT" mode
and will switch to "2 POWER UNITS" mode after a few seconds; the pairing procedure is now complete.
4) Release the WI-TOUCH trigger (N) and turn off by moving the starter device (H) to "0/OFF".
If the machine does not switch from "1 POWER UNIT" to "2 POWER UNITS" mode, repeat the pairing procedure. If the problem recurs more than once,
contact your nearest Authorised Service Centre.
12
HOW TO AVOID DAMAGING SURFACES
WARNING
12.1 Using the machine to wash tyres may damage the tyre and can be dangerous.
12.2 Never point the high pressure jet straight at the tyre.
12.3 Always use the machine at the lowest pressure setting when cleaning in the vicinity of wheels and tyres.
12.4 Never use the "Turbo Lance" for washing any part of the vehicle.
12.5 For further information refer to section: "8.12 Recommended cleaning procedure".
The validity of the warranty is in accordance with the relevant legislation in the country where the product is sold (unless otherwise stated by the producer).
The warranty covers materials, construction and conformity defects during the warranty period, during which time the manufacturer will replace defective
parts and repair the product if not excessively worn, or replace it.
The warranty does not cover components subject to normal wear and tear (valve, piston, water gasket, oil gasket, springs, O-rings, accessories such
as the hose, trigger gun, brushes, wheels, etc.).
The warranty does not cover defects caused by or arising from:
- improper use, misuse, negligence,
- professional use or hire, if the product was sold for domestic use,
- failure to comply with the maintenance instructions provided in this manual,
- repair by unauthorised staff or centres,
- use of non-genuine parts or accessories,
- damage caused by transport, by dirt or foreign bodies, accidents,
- storage or warehousing problems.
Proof of purchase must be submitted to obtain warranty cover.
For after-sales service, contact the store where the machine was purchased.
Warranty