Publicidad
Idiomas disponibles
Idiomas disponibles
bottom part so that the top cover can be
assembled.
Fan body:
• First loosen the two screws located on
the top part of the fan body, where the
downrod is going to be inserted.
• Remove the safety pin from the
downrod and save it. (Pic. 2)
• Then follow this sequence: Insert the
down rod through: the top cover and the
bottom cover (pic. 3)
• Introduce the cables through the down
rod too (Pic. 4)
• If you were unable to thread the cables
through the downrod we suggest that
you remove the hemisphere located on
top of the downrod (pic. 5), proceed as
follows:
• Remove the upper screws located
on the rubber hemisphere and save
them. Keep in mind that one of them
will hold the earth wire extension
cable (pic. 5.3) Remove the safety pin
and save it together with the screws
(pic. 5.2 and 5.1) Then thread the
cables and fix it again.
• To fix the hemisphere again: Insert
the safety pin in the holes on the top
part of the down rod (pic. 5.1) Then
bring up the rubber hemisphere until
all the holes are aligned (pic. 5.2)
Last, fix it with the screws you have
removed earlier and fix the earth
wire with one of them (pic 5.3)
• Once you have inserted the cables,
Fit the rod in the motor housing and
insert again the safety pin previously
removed. Then, tighten the screws of
the motor housing which have been
loosened before (pic. 6)
• Once you have finished, adjust the
bottom cover and hide the connection
between the down rod and the motor
housing. (Pic. 7)
How to assemble the blades:
• To assemble the blades, you need to
remove the LED light plate. In order to
do this, remove the screws from the
plate and save them together with the
plate (fig. 8).
• Insert the blades in the slots and align
the three holes on the blades with the
three holes in the main structure of
the lamp (pic. 9). Fix and tighten using
the screws supplied. The blades are
designed to fit perfectly. The screws
must be vertical with respect to the
blade. Tighten evenly the screws to the
blades to prevent the fan from swinging
(pic. 10). Keep in mind that you need to
turn the light fixture mounting bracket
to gain visual access to the support of
every blade.
• Once you have assembled all blades you
have to install the LED light plate again:
• Put it back in the initial position,
threading the cables coming out
from the motor through the centre of
the panel (pic. 11)
• Place the light plate so that the holes
are aligned with the holes for the
screws you have previously removed
from the light support (pic. 11).
• Then fix the screws on the LED plate.
Please, make sure the lighting kit is
well fixed after you have tightened
the screws (pic. 12).
• Connect the cable coming out from
the motor to the inlet located in the
centre of the LED plate light (pic. 13).
Electrical connections:
• Put the fan on the ceiling bracket
by introducing the down rod in the
receiver bracket and turn it until you
hear a "click" sound, insert the slot
located on the hemisphere of the down
rod, in the tab of the receiver bracket.
(pic. 14).
• Then we can proceed to do the pertinent
electrical connections. See image 05 on
page 9:
• First place the receiver between the
bracket and the fan, with the smooth
part facing upwards (pic. 15).
• Once placed, connect the cables
coming out of the ceiling using the
circuit board located on the receiver
EN
31
Publicidad
