Publicidad
Idiomas disponibles
Idiomas disponibles
advise you to familiarize yourself with the
instructions below.
The fan has 6 power levels that can be
selected through the remote control. It also
has a timer of up to 8 hours.
Remote control:
See picture 07 on page 10.
The device incorporates a remote control,
for a more comfortable and efficient use.
In order for the remote control to work, it
must always be aimed at the fan.
Before you start using it, please take a few
minutes to familiarize yourself with the
functions:
10. Buttons 1 to 6: Press these buttons to
set the fan speed, with 1 being the
lowest and 6 the highest.
11. Fan ON/OFF button: Press it to turn
the device on or off.
12. Winter/summer
Press the button to activate the
winter function or to return to the fan
function (summer mode).
13. 1H: Setting for the fan to turn off
automatically after one hour of
operation.
14. 2H: Setting for the fan to turn off
automatically after two hours of
operation.
15. 4H: Setting for the fan to turn off
automatically after four hours of
operation.
16. 8H: Setting for the fan to turn off
automatically after three hours of
operation.
17. Light ON/OFF button: Press it to turn
on the lights of the device. Press it as
many times as necessary to select
among the different colours of light,
with a choice of three options.
18. Natural wind mode button: press it to
activate the natural wind mode
In order to be able to use the ceiling fan
through the remote control, the receptor
included with this device must be installed
before, as explained in the installation
section of this manual.
function
button:
To use the remote control, you must add 2
batteries to the bottom of the remote.
If your model has LED light with different
colour tones, you can change the colour
temperature of the light by switching it on
and off with the wall switch, the remote
control or, in case of a smart fan, from your
terminal. See picture 08 on page 10.
Each
associated with the receiver
included with the fan.
When you turn off the fan with
the remote controller, the light
settings will be saved according
to the last option you selected.
For example, if the light is set to
the "warm" position when you turn off the
fan, when you turn on the fan again with
the remote controller the light will be set to
"warm" again. However if you turn on/off
the fan with the wall switch the settings
will not be saved and the light will turn on
according to the default settings (some
models do save the settings when using
the wall switch)
First use:
• Switch it on.
• Check the speed and light (if your
model has it)
Using the product with the switch and
the remote controller:
• You cannot control speed with the wall
switch. The wall switch only allows
you to turn it on. Speed can only be
selected with the remote controller.
• You can use the switch to turn on/off
the light. Depending on your model,
light:
• Will automatically turn on when
you press the switch.
• Turn the light on with the remote
controller and then press the switch.
The light will turn off and the settings
will be saved for the next time you
use it. You can check these settings
remote
control
EN
is
33
Publicidad
