Publicidad
Idiomas disponibles
Idiomas disponibles
a damp cloth and a little dishwashing
product.
• Regularly clean the filter.
• Regularly
clean
with a brush. To do this, you will
have to uncouple them from their
corresponding tray with a simple twist
and put them back after cleaning.
• Leave the door slightly open if you are
going to leave the dishes inside the
appliance for a while.
EXTERNAL CARE
The door and the door seal
• Clean the door seals regularly with a
soft damp cloth to remove food deposits.
• When the dishwasher is being loaded,
food and drink residues may drip onto
the sides of the dishwasher door. These
surfaces are outside the wash cabinet
and are not accessed by water from
the spray arms. Any deposits should be
wiped off before the door is closed.
The control panel
If cleaning is required, the control panel
should be wiped with a soft damp cloth
only.
Note: Always follow the warnings marked
on cleaning products.
NTERNAL CARE
Filtering system
The filtering system in the base of the
wash cabinet retains coarse debris from
the washing cycle, including foreign
objects such as tooth picks or shards. The
collected
coarse debris may cause the filters to clog.
Check the condition of the filters regularly,
carefully remove foreign objects and clean
the parts of the filtering system if necessary
with water. Follow the steps below to clean
the filter. (see image 6 on page 7).
• Hold the coarse filter and rotate it 2
anticlockwise to unlock the filter.
Lift the filter upwards and out of the
dishwasher.
• The fine filter can be pulled off the
the
sprinklers
bottom of the filter assembly. The
coarse filter can be detached from the
main filter by gently squeezing the tabs
at the top and pulling it away.
• Larger food remnants can be 4 cleaned
by rinsing the filter under running
water. For a more thorough clean, use a
soft cleaning brush.
• Reassemble the filters in the reverse
order of the disassembly, replace the
filter insert, and rotate clockwise to the
close arrow.
Spray arms
It is necessary to clean the spray arms
regularly for hard water chemicals will
clog the spray arm jets and bearings.
To clean the spray arms, follow the
instructions below (see image 7 on page 7):
• To remove the upper spray arm, hold
the nut, rotate the arm clockwise to
remove it.
• To remove the lower spray arm, pull out
the spray arm upward.
• Wash the arms in soapy and warm
water and use a soft brush to clean the
jets. Replace them after rinsing them
thoroughly.
TROUBLE SHOOTING
On many occasions you will be able to
solve the faults that appear in your device
yourself, using the Problems-Solutions
table that is presented in this manual (see
table 02 on page 12). Otherwise, call our
Customer Service.
If you detect a fault that cannot be repaired
by yourself and prevents the use of the
appliance, disconnect it from the current
and from the electrical panel.
Various error codes may appear on the
control panel. (See table 05 on page 20).
Any repair or replacement
of electrical wiring must be
carried out by a competent
technician,
EN
otherwise
it
39
Publicidad
