Publicidad
Idiomas disponibles
Idiomas disponibles
assembled.
Fan body:
• First loosen the two screws located on
the top part of the fan body, where the
downrod is going to be inserted.
• Remove the safety pin from the
downrod and save it. (Pic. 2)
• Then follow this sequence: Insert the
down rod through: the top cover and the
bottom cover (pic. 3)
• Introduce the cables through the down
rod too (Pic. 4)
• Once you have inserted the cables,
Fit the rod in the motor housing and
insert again the safety pin previously
removed. Then, tighten the screws of
the motor housing which have been
loosened before (pic. 5)
• Once you have finished, adjust the
bottom cover and hide the connection
between the down rod and the motor
housing. (Pic. 6)
How to assemble the blades:
• Take the screws and washers provided
from the accessory bag. Place the
blades so that the two holes in the
blades line up with the two holes on the
bottom of the fan body (at the narrowest
part). Fix and tighten using the screws
and washers supplied. The blades are
designed to fit perfectly. The screws
must be vertical with respect to the
blade. Tighten evenly the screws to the
blades to prevent the fan from swinging
(pic. 7)
Electrical connections:
• Put the fan on the ceiling bracket
by introducing the down rod in the
receiver bracket and turn it until you
hear a "click" sound, insert the slot
located on the hemisphere of the down
rod, in the tab of the receiver bracket.
(pic. 8).
• Then we can proceed to do the pertinent
electrical connections. See image 05 on
page 8:
• First place the receiver between the
bracket and the fan, with the smooth
part facing upwards (pic. 10).
• Once placed, connect the cables
coming out of the ceiling using the
circuit board located on the receiver
support. Connect the phase wire to L
and the neutral wire to N.
• Once the electrical connections are
completed, slide the top cover up
and align the holes with the screws
you have previously loosened on the
receiver support. Turn it until it fits and
then tighten the screws. (Pics. 11 and 12)
Once you have finished the installation
make sure the product works correctly. Pay
special attention to any strange oscillation
or malfunction in any of the fan parts.
In case the product shows any imbalance
or vibration, you can use the balancing kit
included to adjust it.
Remote control connection:
See picture 05 on page 8.
L : AC IN 220-240V
N : AC IN 220-240V
Blade balance kit:
Included in the purchased product you will
find a kit supplied to prevent the blades
from moving unbalanced.
The fan may wobble during functioning
due to an irregularity in the blades or
blade support. Also, improper installation
or an inclined angle can cause additional
problems.
It is recommended to follow the next
procedure to solve any of these problems :
• Make sure that all blades are screwed
firmly into their mounts and are tight to
the fan body.
• Looking at the fan from below, check
and make sure that no blade holder is
bent so all the blades are in the correct
position.
• Using a ruler you can check the blade
route. Simply place the ruler against the
roof vertically, and note the distance
EN
31
Publicidad
