Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
from the edge of the blade to the roof.
Carefully spin the blades with your
hand to check all the blades. If the
blades are not aligned, the holder can
be slightly bent up or down to align it
with the rest of the blades.
If after following all these steps the problem
is not solved, a small adjustment must be
made using the balance kid provided.
• Turn the fan on and change the speed
until the most noticeable swing occurs
(usually the highest speed).
• Turn off the fan. Select a blade and
place the balancing clip on the edge of
it, between the holder and the tip.
• Turn the fan back on and see if the tilt
has improved or worsened. Turn the fan
off and change the clip to another blade
to check again. Repeat this process for
all blades and note which blade has the
most noticeable improvement.
• Put the clip back on the blade where
you noticed the greatest improvement.
Move the clip along the blade and turn
on the fan to find the position where the
clip offers the better improvement.
• Next, remove the clip and place one of
the balance weights on the point where
the clip was placed. To do so separate
the white sticker with your fingernails
or, if necessary, carefully use a knife or
scissors.
• Make sure the problem has been solved.
If the imbalance persists, repeat the
process. You can use light weights on
those blades that may need it.
USING THE APPLIANCE
This device is very easy to use and does
not require much knowledge. However, we
advise you to familiarize yourself with the
instructions below.
The fan has 3 power levels that can be
selected through the remote control. It also
has a timer of up to 4 hours.
32
Remote control:
See picture 07 on page 9.
The device incorporates a remote control,
for a more comfortable and efficient use.
In order for the remote control to work, it
must always be aimed at the fan.
Before you start using it, please take a few
minutes to familiarize yourself with the
functions:
9.
LOW: Fan turning at minimum
speed.
10. MED: Fan turning at medium speed.
11. HI: Fan turning at maximum speed.
12. STOP: To turn off the fan
13. White button: This button does not
work on this model. Only used to
connect the receiver to the remote
control.
14. 1H: Setting for the fan to turn off
automatically after one hour of
operation.
15. 2H: Setting for the fan to turn off
automatically after two hours of
operation.
16. 4H: Setting for the fan to turn off
automatically after three hours of
operation.
17. Winter/summer
Press the button to activate the
winter function or to return to the
fan function (summer mode).
In order to be able to use the ceiling fan
through the remote control, the receptor
included with this device must be installed
before, as explained in the installation
section of this manual.
To use the remote control, you must add 2
batteries to the bottom of the remote.
Each
associated with the receiver
included with the fan.
First use:
• Switch it on.
• Check the speed and light (if your
model has it)
Using the product with the switch and
function
button:
remote
control
is
Publicidad
