Publicidad
Idiomas disponibles
Idiomas disponibles
Model: 6006
IGNITIoN INSTRUCTIoNS
1. CHECK VALVES
Turn knob to oFF position�
STEP 01
Push in knob and release� Knob should spring back�
STEP 02
If knobs do NoT
If knobs
do NoT spring back, replace valve assembly before using appliance.
spring back, replace valve assembly before using appliance.
Rotate knob to loW then turn back to oFF� Knob should
STEP 03
turn smoothly�
If burner does not ignite with open gas supply valve, gas
will continue to flow out of burner and could accidentally/
inadvertently ignite with risk of injury.
Ensure gas is o at the supply shut o valve before checking
appliance valves.
3. ALWAYS CHECK BURNER FLAME BEFORE USE.
light burners and rotate knobs from HIGH to loW�
STEP 01
look below the cooking surface to view burners� When knob
STEP 02
is at HIGH, flames should be larger than when knob is at loW�
HEALTHY FLAME PATTERN
❶ ❶
❷ ❷
❸ ❸
❶ ❶
Flickers of yellow color.
Flickers of yellow color.
❷ ❷
dark blue color.
dark blue color.
❸ ❸
Vibrant blue.
Vibrant blue.
BLACKSTONEPRODUCTS.COM/SUPPORT
3. ALWAYS CHECK BURNER FLAME BEFORE USE.
WARNING
YELLOW OR IRREGULAR
If there is a sudden drop or low
If there is a sudden drop or low
flame issue, please reference the
flame issue, please reference the
Troubleshooting chapter.
Troubleshooting chapter.
USING YOUR BLACKSTONE
2. BATTERY POWERED ELECTRIC IGNITION
2. BATTERY POWERED IGNITION
Before starting ensure all knobs are turned to oFF� ❶ ❶
Before starting ensure all knobs are turned to oFF� ❶ ❶
Insert one (1) AA
Insert one (1) AA
STEP 01
STEP 01
battery (not included) under the
battery (not included) under the
ignitor button�
battery cap�
Screw the cap into place over the
Screw the button into place over
positive terminal�
the positive terminal�
Turn gas oN by turning
Turn gas oN by turning
STEP 02
STEP 02
the gas cylinder handwheel
the gas cylinder handwheel
counterclockwise 1 to 3 turns�
counterclockwise 1 to 3 turns�
STEP 03
❷ ❷ Push and hold the ignitor button�
STEP 03
❸ ❸ Push and turn the control knob counter-clockwise to HIGH�
❶ ❶ Push the control knob in to
(Release the ignitor button when the burner lights�)
start gas flowing�
❹ ❹ Adjust the temperature to desired level�
❷ ❷ Turn the control knob
counter-clockwise to activate
❶ ❶
the starter�
❸ ❸ Check flame and adjust the
temperature to desired level�
❸ ❸
❹ ❹
IF IGNITION DOES NOT OCCUR IN 5 SECONDS:
Turn the burner control knob oFF�
STEP 01
Wait 5 minutes�
STEP 02
Repeat the lighting procedure�
STEP 03
If burner does not ignite, please reference the Troubleshooting chapter.
If burner does not ignite, please reference the Troubleshooting chapter.
IF IGNITION DOES NOT OCCUR IN 5 SECONDS:
| OWNER'S MANUAL
1 to 3 turns
1 to 3 turns
1 to 3 turns
1 to 3 turns
❶ ❶
❷ ❷
❷ ❷
❸ ❸
17
2. E
d
Mak
STEP
(op
unti
pud
STEP
❶ ❶
star
❷ ❷
cou
star
❸ ❸ C
the
leve
Note
will b
Publicidad
