Publicidad
Idiomas disponibles
Idiomas disponibles
Troubleshooting
Should you have any problems during the operation of this compact disc player please check that all the controls are set to their proper
positions and that all connections are correct (refer to this manual for the proper procedures). If a problem persists refer to the advice
below.
If the problem can not be corrected with the instructions below, write down the model and serial number and all pertinent data regard-
ing warranty coverage, as well as a clear description of the problem, and contact your nearest AKAI service centre.
The CD player will not turn on.
© Check to see if the power cord is connected securely to the house-
No sound.
hold, timer or amplifier's-AC outlet.
¢ The connected amplifier's input selector and you? control are fot
set properly.
¢@ Condensation.
Leave the CD player's power turned on for more than 30 minutes.
® The compact disc is not loaded properly.
The CD player goes into the playback mode
| e¢ A compact disc is loaded.
when it is turned on.
Take out the compact disc after playback has finished.
Distorted playback or sound loss during play-
@ The compact disc is dirty or scratched.
back.
Clean or replace the compact disc.
Timer controlled playback will not begin.
@ The compact disc is not loaded.
Load the compact disc for timer controlled playback.
® The power was not turned on.
Make sure to switch the power on before timer controlled sparation:
Playback will not start.
@ The compact disc is not loaded properly.
Load the compact disc with its label facing up.
¢ Condensation.
Leave the CD player's power turned on for more than 30 minutes.
Remote control will not operate.
e The batteries are weak.
Replace ail the batteries.
@ The CD player is in direct sunlight or is too close to a strong light
source.
Change the CD player's position.
Direct search function will not take place.
e@ The PROG indicator is on the FL display.
Press the CLEAR button to cancel programmed playback, or use the
é<¢ or BPI buitons to find the track you want.
Auto edit will not function.
® The PROG indicator is on the FL display.
:
Press the CLEAR button to cancel programmed
playback, then
press the EDIT button.
Ail tracks cannot be programmed during auto
© Recording time is not set properly.
edit programme.
Select the proper recording time for the cassette being used after
pressing the EDIT button.
The same tracks are recorded during auto edit
| e Repeat playback is engaged.
i
._programme playback.
Cancel repeat playback by depressing the REPEAT button before
starting playback.
The FL display does not appear.
e Press the DIMMER button until the FL display appears.
16
Publicidad
