Beurer EM 44 Manual De Instrucciones página 17

Program 13:
Program 13 is a preset program that you can also personalize. In this program, you can set the impulse frequency between 1 and 120
Hz and the impulse width between 50 and 250 μs.
1. Place the electrodes on the desired area for treatment. For positioning suggestions, see the „Positioning the Electrodes" section.
Connect the cables to the main unit. Select Program 13, as described in step 3 in the previous section.
2. Select the desired impulse frequency using the UP/DOWN buttons and press the ENTER button to confirm.
3. Select the desired impulse width using the UP/DOWN buttons and press the ENTER button to confirm.
4. Select the desired treatment time using the UP/DOWN buttons and press the ENTER button to confirm.
5. Select the desired impulse intensity.
Program 14:
Program 14 is a preset burst program that you can also personalize. In this program you can set an impulse width between 50 and
250 μs.
1. Place the electrodes on the desired area for treatment. For positioning suggestions see the „Positioning the Electrodes" section.
Connect the cables to the main unit. Select Program 14.
2. Select the desired impulse width using the UP/DOWN buttons and press the ENTER button to confirm.
3. Select the desired treatment time using the UP/DOWN buttons and press the ENTER button to confirm.
4. Select the desired impulse intensity.
Program 15:
Program 15 is a preset program that you can also personalize. In this program, you can set the impulse frequency between 1 and 120
Hz. The impulse width changes automatically during the stimulation treatment.
1. Place the electrodes on the desired area for treatment. For positioning suggestions see the „Positioning the Electrodes" section.
Connect the cables to the main unit. Select Program 15.
2. Select the desired impulse frequency using the UP/DOWN buttons and press the ENTER button to confirm.
3. Select the desired treatment time using the UP/DOWN buttons and press the ENTER button to confirm.
4. Select the desired impulse intensity.
Custom Function
The Custom Function is a special setting to allow you to access your personal program directly.
Your individual program settings are recalled and activated when the device is switched on.
17