Samsung WW1 D Serie Manual De Instrucciones página 14

STEP 4 Connect the water hose
NOTE
These instructions are for the threaded water tap. For more detailed instructions or instructions for connecting the
water hose to a non-threaded water tap, please visit the website on the cover of this manual and check the web
manual.
1. Connect the water hose to the water tap, and then turn it to the right to tighten.
CAUTION
Before connecting the water hose, make sure there is a rubber washer in the hose connectors. Do not use the hose if
the washer is damaged or missing.
2. Connect the other end of the water hose to the inlet valve on the back of the washing machine, and then turn it
to the right to tighten.
3. Slowly open the water tap and check if there are any leaks around the connection areas. If there are water leaks,
repeat step 1 and 2.
WARNING
If there is a water leak, stop operating the washing machine and disconnect it from the electrical supply. Contact a
local Samsung service centre in case of a leak from the water hose, or contact a plumbing technician in case of a leak
from the water tap. Otherwise, this may cause electric shock.
CAUTION
Do not stretch the water hose by force. If the hose is too short, replace the hose with a longer, high-pressure hose.
STEP 5 Position the drain hose
The drain hose can be positioned in three ways:
Over the edge of a wash basin
CAUTION
Remove the lid on the sink drain pipe branch before connecting the drain pipe to it.
14 English
DC68-04508C-00_IB_B-PJT-B11_WASHER_SimpleUX_EN.indd 14

In a drain pipe

In a sink drain pipe branch
2023-12-18
60 cm
11:27:57