Cleaning And Maintenance - NEO FOLLOWER 35ST Manual De Usuario

• Framing: Profile from up to down.
Instruction: profile according to silkscreen instruc-
tion.
Beam angel adjustment instruction
Adjust beam angle: linearly adjusting beam angel
from 5.5° to 18° Instruction: move sliders on both
sides to focus and zoom. (Attn: must keep both
sides move to same value).

6. CLEANING AND MAINTENANCE

The following points have to be considered during
the inspection:
1. All screws for installing the devices or parts of
the device have to be tightly connected and
must not be corroded.
2. There must not be any deformations on the
housing, color lenses, fixations and installation
spots (ceiling, suspension, trussing).
3. The electric power supply cables must not
show any damage, material fatigue or sedi-
ments. Further instructions depending on the
installation spot and usage have to be adhered
by a skilled installer and any safety problems
have to be removed.
CAUTION!
Disconnetc from mains before starting
maintenance operation.
P. 8
Neo Follower 35ST -
English version
In order to make the lights in good condition and
extend the life time, we suggest a regular cleaning
to the lights.
1. Clean the inside and outside lens each week to
avoid the weakness of the lights due to accu-
mulation of dust.
2. Clean the fan each week.
3. A detailed electric check by approved electrical
engineer each three month, make sure that the
circuit contacts are in good condition, prevent
the poor contact of circuit from overheating.
We recommend a frequent cleaning of the device.
Please use a moist, lint- free cloth. Never use alco-
hol or solvents. There are no serviceable parts in-
side the device except for the lamp. Please refer to
the instructions under "Installation instructions".
Should you need any spare parts, please order
genuine parts from your local dealer.