MPM MZE-23 Manual De Instrucciones página 26

During operation, parts of the housing located in the
immediate vicinity of the working elements
DEVICE
DESCRIPTION
1. Water tank with a capacity of one point five liters
2. Opening with a hinged lid for pouring water. 3.
Button to unlock the iron
4. Operation status indicators
5. Steam release setting button
6. Cleaning button
CONTROL PANEL
1. Cleaning
2. No water in the tank
3. Strong steam mode
4. Automatic shutdown (Fireman
function)
5. Energy-saving steam mode
WARNING! The iron has an "AUTO SHUT OFF" function ("FIREMAN" FUNCTION).
This is an electronic, safe iron shutdown when it is not used for a long time. The
protection works both when the iron is lying flat on the surface and when it is
placed in a vertical position. The function is indicated by an audible signal and
the light (4) illuminating.
VERTICAL STEAM FUNCTION
This function allows steam to be ejected in a vertical position. You can use this function to iron
creases on hanging clothes or curtains.
BEFORE FIRST USE:
6. Remove all stickers, covers, and protective film from the iron soleplate.
7. Fully extend the power cord and steam supply hose.
8. Place the iron base on a stable, flat surface.
9. Place the iron on the surface adapted for this purpose, located on the base of the iron.
WARNING! When using the iron for the first time, smoke may appear and white residue may come
out of the iron soleplate. The smoking phenomenon will stop after a short while, and the white
residue should disappear after a few uses.
FILLING THE WATER TANK
1. Make sure the device is disconnected from the electrical network.
2. Tilt the cover of the water filling hole (2).
3. Fill the tank with water up to the maximum level (MAX level marked on the tank).
If tap water is hard, it is recommended to use distilled or demineralized water
WWW.MPM.PL
7. Power button
8. Steam shot button
9. Cable connecting the iron to the steam
generator with a length of 1.55m
10. Ceramic soleplate
11. Place to wind the connecting cable
User Manual
5