MPM MZE-23 Manual De Instrucciones página 27

When the water runs out in the tank, the pump will turn off and the indicator light (4) will
come on. In this case, disconnect the power and refill the tank.
WARNING! Only water should be poured into the tank. Another liquid could damage the
device.
WARNING! Do not fill the tank above the MAX indicator.
TEMPERATURE SETTING
Check the ironing instructions on the label of the garment intended for ironing.
The iron is equipped with electronic automatic temperature control. There is no
need to manually set the temperature.
DEVICE USAGE
It is recommended to place the iron on its base, which is equipped with non-slip feet, protecting the
iron from damage. Do not place the iron on a metal support. It is recommended to use a
mesh/ventilated ironing board to avoid excessive steam condensation.
When choosing an ironing board, pay attention to its stability. Make sure that the space for the steam
station has the appropriate load-bearing capacity (the weight of a steam generator with a full tank is
about 5 kg). It is not recommended to use boards with chipboard tops.
STEAM IRONING
CAUTION! The iron emits a large amount of hot steam! Risk of burns!
1. Fill the tank with water according to the instructions in the 'Preparing for use' section.
2. Connect the device to the power supply.
3. Steam ironing is only possible after the heating is finished. Otherwise, water may come out of the
holes.
4. Wait until the indicator stops flashing. Then the soleplate is properly heated. 5. Select the steam
shot power using the button (5).
6. Iron clothes while holding down the steam shot button (8).
TIP! To get rid of stubborn creases, the iron is equipped with a steam boost function. To activate
it, press and release the steam boost button quickly for about 2 seconds.
DRY IRONING
1. Do not press the steam boost button (8) while ironing
DRY IRONING
Hanging curtains and clothes (jackets, suits, coats) can be ironed by holding the iron vertically.
1. Place the iron foot parallel to the fabric at a distance of a few centimeters and move the iron
while pressing the steam boost button (8).
WARNING! Never direct steam towards people and animals!
CLEANING AND MAINTENANCE
1. After use, disconnect the power cord from the electrical outlet. 2. Wait
for the iron and iron base to cool down.
3. Wipe the iron with a damp cloth.
WWW.MPM.PL User Manual
6