Mark LIGHT TRUSS BAT 41 Manual Del Usuario página 5

Connect the DMX512 input terminal to the controller. After that, connect the output terminal to the
next device. Repeat this step with all fixtures in the chain. To prevent system errors, the last device in a
DMX chain needs to be equipped with a terminating resistor (120 ohm, 1/4 Watt).
Pin occupation
Pin 1: Ground
Pin 2: Pin -
Pin 3: Pin +
To connect more than one unit in a chain, please, follow this picture. The output of the first unit must
provide to the next DMX input of the signal, this way it is possible to send the signal to all the devices
in the chain.
4