Publicidad
Idiomas disponibles
Idiomas disponibles
6. Battery change
Open the battery compartment on the back of the bell transmitter by loosening
the two screws and removing the cover.
Remove the circuit board and turn it over. Then remove the batteries from the
battery compartment and replace them with 2 new CR2016 batteries. Ensure
that the polarity of the contacts is correct. The polarity is indicated on the battery
compartment.
Reinsert the circuit board and screw the cover of the transmitter back on.
7. Setting the ringtone and volume
Volume control: Press the volume button on the receiver to switch between high
and low volume.
Set the ringtone:
1.
Press the forward or backward button to select your favourite ringtone, the
receiver will play the selected ringtone.
2.
Please follow the settings described in chapter 8 „Pairing" to synchronise
the new ringtone. The new ringtone is set for the last synchronised trans-
mitter.
8. Pairing
1.
Please select your favourite ringtone before pairing.
2.
Press and hold the volume button for 5 seconds until you hear a „ding-
dong" and the LED indicator starts flashing.
3.
Press the „Ring" button on the transmitter to send a signal to the receiver
4.
The device is then paired with the new ringtone.
Note:
•
Pairing mode is cancelled automatically after pairing is complete.
•
Pairing mode only takes 5 seconds.
12
English
Publicidad
