Publicidad
Idiomas disponibles
Idiomas disponibles
9. Installation
Important: Test the range of the doorbell before installation.
Simply connect the receiver to a 230V socket in the desired room.
Transmitter installation method 1: Double-sided adhesive tape (preferred
installation method)
1.
Once you have found a suitable location, please clean the flat area where
you want to attach the transmitter.
2.
Tear off one side of the double-sided adhesive tape and stick it to the un-
derside of the transmitter. Tear off the other side and press the transmitter
against the wall for approx. 10 seconds.
Transmitter installation method 2: Screws/anchors (optional installation
method)
Prepare a drill, a Phillips screwdriver and a slotted screwdriver before installation.
1.
Make two marks where the two fixing holes are located.
2.
Drill two holes at the marked points and then insert the 2 dowels supplied.
3.
Screw on the base of the transmitter.
4.
Attach the transmitter to the base.
10. Reset device
Press the „Forward" button for 5 seconds to reset the receiver to the default set-
tings. If the receiver emits a beep and the LED flashes, this means that the reset
was successful and the default settings have been restored.
English
13
Publicidad
