MESTIC SMART ADVENTURE MPS-3000 Instrucciones De Uso página 27

Car charging
The power station can be charged using a car charging port. It should be charged after the car starts to avoid car
battery loss and failure to start. At the same time, ensure a good connection between the car charging port and
the cigarette lighter. We take no responsibility for any loss caused by improper operation.
Battery expansion
The power station supports connection with 6 expansion battery packs at the same time for larger capacity.
Please refer to the user manual of the battery pack for details.
Note:
1. Before connecting the battery pack, please make sure both the power station and battery pack are off.
2. After the battery pack is connected, check if the battery icon is shown on the displays of both the power
station and the battery pack.
3. While charging, please do not connect or remove the battery pack. If there is a need to connect or remove
the battery pack, turn off the power station prior to using it.
4. Please do not touch the metal terminals. If there is foreign matter on the metal terminals, gently and
carefully clean it with a dry cloth.
Parallel mode of the power station and 1 expansion battery pack:
1. Turn off the power station and the expansion battery pack.
2. Plug one end of the cable to the expansion port of the power station and the other and to the power
output of the battery pack.
3. After parallel connection, press the power button of the power station to enable the power station and
battery pack to show the current capacity. The power station shows the paralleled quantity, and capacity is
expanded.
4. After parallel connection, connect ports of the power station for charging or discharging.