Publicidad
Idiomas disponibles
Idiomas disponibles
DIGITOP MULTIMETER - DMT600 - 6 in 1
USER MANUAL
INDEX
A. INTRODUCTION
B. SAFETY RULES
C. INTERNATIONAL ELECTRICAL SYMBOLS
D. FEATURES
E. TECHNICAL DATA
F. OPERATION PANEL
G. HOW TO MAKE MEASUREMENTS
H. ACCESSORIES
A. Introduction
The DMT600 Series multimeter is a portable device with stable and reliable operation. It allows you to
measure:
• DC direct current voltage
• AC alternating current voltage
• intensity of the DC current
• resistence
• operation of a diode
• buzzer function (buzzer)
B. Safety rules
• This multimeter complies with EN61010-1: 2010, pollution degree 2, CAT II 500V, CAT III 300V with
double insulation. Use the appliance only as indicated in this manual. Otherwise the protection may
prove inadequate.
• Before use, carefully check the insulation of the probes and make sure there are no damaged parts.
• Replace the battery as soon as the battery indicator shows low level. ". With a low battery, the
multimeter may produce erroneous readings. Before replacing the battery make sure the probes are
disconnected.
• Set the device to the correct function and range before taking measurements.
• Measured values beyond the maximum range may damage the device or cause shock.
• To avoid damage to the device, do not turn the knob during measurement.
• When measurement is performed on an effective voltage greater than 60V DC or 30V rms AC, special
attention must be paid to the danger of shock.
• For replacement, only use fuses of the correct type and value:
• F 0.5A/500V (5 x 20 mm)
• F 10A/500V (5 x 20 mm)
• Do not use or store the multimeter in a high temperature, humidity environment.
• Do not modify the internal circuit to avoid compromising the operation of the appliance and the
safety of the user.
English
Publicidad
