Publicidad
Idiomas disponibles
Idiomas disponibles
1. Select a suitable location on the wall, which should be firm and level. Check that there is a
mains socket close by.
2. The distances vary depending on the heater model.
3. Open the package box and check that all fixing accessories are present, it is a good idea
to keep the product box for storing out of season.
A
B
1. While respecting the previously indicated safety measurements, make two marks on the
wall according to measurement "e" indicated in Table 1 and at a height of 695 mm from the
floor (not from the skirting board).
2. At the marked area drill two 10 mm diameter holes, with a minimum depth of 60 mm.
3. Push the two plugs (D) into the two holes and secure the two hooks (C) with the two screws
(D).
4. Screw the two support brackets (A) (or one support bracket, depending on the model) to
the rear part of the heater with the four screws (E) (or two screws, depending on the mod-
el).
E NGL I SH
8
WALL INSTALLATION
C
D
ASSEMBLY
Skirting board
E
F
Publicidad
