Bestron PURE&CLEAN AVC850A Manual De Instruccion página 19

OPERATION - General information
The below description goes with the image on page 2.
1. Tube connection and release button
2. Dust container release button
3. On/off switch
4. Handle
5. Charging port
6. Exhaust opening
7. Dust container
The text below refers to the images found on page 2.
OPERATION - Charging the battery
1. Plug the adapter's charging plug into the charging port (5) of the vacuum cleaner.
2. Plug the adapter (11) into the wall socket. The indicator lights on top of the appliance start flashing in red.
3. Allow the vacuum cleaner to charge (about 4 hours). The adapter may become slightly warm whilst it is
charging; this is normal and does not indicate that the appliance is defective. When the device is fully
charged, the indicator lights will stop flashing, then light up in green.
4. Remove the adapter plug from the mains socket. The indicator lights go out.
OPERATION - Use
1. Powerful cordless hand-held vacuum cleaner for about 30 minutes of continuous operation.
2. Click the tube (10) or one of the included brush tools into the tube connection (1) (see figure 2A). When
using the tube, subsequently click one of the included brush tools into the end of the tube. To remove an
accessory, push the button (1) at the top of the tube connection (see figure 2B) and pull it out.
3. Press the on/off switch (3) and start vacuum cleaning.
4. Press the on/off switch again to activate the Power-Turbo function.
5. Press the on/off switch again to turn off the appliance.
ACCESSORIES
This vacuum cleaner is supplied with four brush tools (see figure 3 and 4):
• a motor driven turbo nozzl (9) for optimum suction performance on hard floors and carpet;
• a combined tool with a large brush (12) for cleaning delicate or irregular surfaces and a furniture suction
nozzle (13) for furniture, Venetian blinds, and similar;
• a combined tool with a small brush (14) and a crevice tool (15) with a narrow nozzle, for cleaning radiators,
window frames, crevices, small openings, and similar.
OPERATION - Storage after use
This vacuum cleaner is supplied with a wall mount (16), which can be attached to the wall using two screws.
Place the vacuum cleaner and the accessories onto the wall mount to store them neatly in a fixed place
(figure 4).
CLEANING AND MAINTENANCE - Removing waste from the dust container
1. Do not empty the dust container during charging. Remove the adapter from the wall socket.
2. Remove the tube from the vacuum cleaner.
3. Hold the vacuum cleaner above a waste-bin.
4. Press the button (7) to open the bottom flap (8) (see figure 5).
5. If so required, use your hand to remove any waste sticking to the container.
6. Close the bottom flap, and press until it clicks into place.
8. Dust container bottom flap release button
9. Motor-driven turbo nozzle
10. Tube
11. Adapter
12/13. Large brush tool / Furniture suction nozzle
14/15. Small brush tool / Crevice tool
16. Wall mount
19 19
EN EN