Publicidad
Idiomas disponibles
Idiomas disponibles
1
1,2,3,4
3
2,4
6
The unit can be turned on at a specified time every day with the
built-in timer.
Preparation
Make sure the clock is set correctly. (See page 16).
Use the remote control.
1
2
3
Press
TIMER
once
while
pressing
SHIFT
to
display "0", then press 11 SET within 4 seconds.
"O"
is displayed and the hour flashes.
If you press 11 SET after 4 seconds, another operation may
start.
Designate
the hour
of the timer-on
time
by
pressing
*
DOWN
or *
UP, then
press
II
SET. Repeat to designate
the minute of the
timer-on time.
After you designate the timer-on time, one of the source names
flashes on the display.
Press
FUNCTION
repeatedly
to select a source,
then press II SET.
The selected source name flashes
The -
and ~
are also available to select a source.
If TUNER is pressed, the band cannot be selected in this
step.
4
5
6
Select the duration for the timer-activated
period
with U
DOWN or _
UP, then press 11 SET.
The duration for the timer-activated period can be set between
5 and 240 minutes in 5-minute steps.
Prepare the source.
To listen to a CD, load the disc.
To listen to a ta~e, insert the tape into deck.
To listen to the radio, tune in to a station.
To listen to the eaui~ment connected to VIDEO/AUX jacks,
set the timer of the connected source (with an external timer)
and prepare for the play.
Press POWER to turn the unit off after adjusting
the volume and tone.
"@"
remains on the display after the power is turned off (timer
standby mode).
When the timer-on time is reached, the unit turns on and
begins play with the selected source.
The volume level is automatically set to 20 when the power is
turned off with the volume level set to
21
or more.
To check the specified time and source
Press TIMER while pressing SHIFT on the remote control. The
timer-on time, the selected source name and the duration for
the timer-activated
period flash alternately for 4 seconds.
To cancel timer standby mode temporarily
Press TIMER repeatedly while pressing SHIFT on the remote
control until "0" or "O
REC"
disappears on the display.
To restore the timer standby mode, press TIMER once or twice
while pressing SHIFT to display "@" or"0
REC".
Using the unit while the timer is set
You can use the unit normally after setting the timer.
Before turning off the power, carry out step 5 to prepare the
source, and adjust the volume and tone.
Timer playback and timer recording will not begin unless the
power is turned off.
Connected equipment cannot be turned on and off by the built-
in timer of this unit. Use an external timer.
.Wb ,.M . . ... . . . . .. . ... . . . . . .
.m., .. ...
..h..._..=...Q_.e.w.
>-ww.m.mwY.,.~>~.
*&,@,~
,,_W,&—=~8,.*,&-~..&
&,~~~~~>-*,,:~.~
TIMER RECORDING
Timer recording is applicable for TUNER and AUWVIDEO (with
an external timer) sources only.
Press TIMER repeatedly while pressing SHIFT on the remote
control until "0
REC"
appears on the display, then press II
SET within 4 seconde.
Carry out the steps of "SETTING THE
TIMER from step 2 and insert the tape to be recorded on into
deck after step 5.
17EPK2L
SH
Publicidad
