Publicidad
Idiomas disponibles
Idiomas disponibles
Operation (cont'd)
Note: To retract the rollers without bending after the
cam locks them in place, pump the lever below the
2" split roller several times. If this does not release
the cam, lift the tail of the conduit while pumping the
release lever. Otherwise, advance the shoe forward
just enough for the cam to release, and then unload.
Squeeze Roller
Release Lever
c. For all other conduit, press BEND while making
sure the bend mark stays at the front of the hook
until the conduit contacts the tail roller.
5. Continue to press BEND until the pendant display is
close to the desired reading. Use JOG to complete
the bend. JOG will advance the shoe about 1/2"
and help prevent accidental overbending. The dis-
played angle in the pendant is the shoe rotation and
does not include springback in the conduit. Refer to
the Bend Angle Chart in the "Bending Instructions"
section of this manual for display readings for
common bend angles.
6. Press UNLOAD to free the conduit.
7. Twist the conduit to release it from the hook and
remove it from the shoe.
Greenlee Tools, Inc.
854DX Electric Bender
Programmed Bending
If an angle is preset into memory, the bender will auto-
matically stop at that angle.
Note: "Angle" represents the angle of the shoe and
does not include conduit springback. The digital display
chart shown in this manual and on the decal on the
bender provides display readings for common bend
angles.
1. Select the angle by using the ANGLE SELECT p
or ANGLE SELECT q button on the pendant to
change the programmed angle. A single press
changes the angle by 1°. Holding down an
ANGLE SELECT key changes the angle rapidly in
5° increments. Pressing CLEAR resets the pro-
grammed angle back to 0°.
This programmed angle stays in the memory until
CLEAR is pressed, a new angle is selected, or the
power is turned off. The programmed angle remains
in the pendant display for about 2 seconds and then
reverts to the actual shoe angle.
2. Press BEND until the bender stops. The bender
may slow down before reaching the selected
angle. This is normal. When the bender stops at
the programmed bend, the pendant display blinks
twice with the programmed angle. To continue
a bend, reset the programmed angle with the
CLEAR button, or increase the programmed angle
to be greater than the actual shoe angle with the
ANGLE SELECT p button.
12
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070
Publicidad
