Publicidad
Idiomas disponibles
Idiomas disponibles
Operation (cont'd)
Optional 02840 Shoe Group for
PVC-Coated Conduit Bending
This bender is compatible with the single-shoe 02840
PVC Shoe Group. The bender must be in COATED PIPE
mode, which allows the bender to display the correct
shoe angles on the pendant when using the single PVC
shoe and roller supports.
Setup
1. Disconnect power to the bender.
2. Position the bender head in the vertical position.
3. Remove the short hitch pin and 1/2" to 1" roller unit,
and lift the handle from the roller support tubes.
4. Pull the ring of the lock pin in the shoe, and while
pulling the lock pin slide the shoe off the main
spindle, as shown below.
Pull ring.
5. Install the PVC bending shoe onto the main spindle
and align the drive studs in the shoe with the holes
in the sprocket.
Greenlee Tools, Inc.
6. Install the shoe retaining collar, as shown below.
7. Install the 1/2" to 1-1/4" PVC-coated conduit roller
support by sliding it between the existing rollers
from the right side of the bender and dropping it
down so it hooks on the bender frame roller support
tubes, as shown below.
Remove
hitch pin.
8. Reinstall the lift handle and short hitch pin.
13
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070
854DX Electric Bender
Publicidad
