Publicidad
Idiomas disponibles
Idiomas disponibles
Maintenance
Reinstalling 1/2" to 2" Combination Shoe
1. Slide the shoe onto the spindle and orient it so the
EMT hook (silver) is about 90° clockwise of the
sprocket spoke with two drive lug holes.
2. Pull the ring on the shoe retaining pin to clear the
spindle and fully slide on the shoe so that the drive
lugs engage into the sprocket holes.
3. Verify that the retaining pin is engaged into the
spindle and the shoe is secured.
Replacing the Fuse
For continued protection against risk of fire and
electric shock, replace ONLY with same manufacturer,
type, and rating of fuse.
Failure to observe this warning could result in severe
injury or death.
If the fuse needs to be replaced, use only a Cooper
Bussmann GBB-30 Very Fast-Acting fuse, 1/4" x 1-1/4"
(6.3 x 32 mm).
Zeroing the 854DX
The shoe timing is set at the factory and should never
need to be adjusted unless the encoder assembly is
removed.
1. Pivot the bending head to the vertical bending
position.
2. Press the BEND or UNLOAD button until the green
IMC/rigid hook is in the loading position (or –5°), as
shown below.
Lock
Pin
Green
Hook
Greenlee Tools, Inc.
854DX Electric Bender
Note: The bender can be zeroed without completely
removing the shoe only if the bender is on a level
surface.
3. To zero the bender without completely removing the
shoe, follow these steps; otherwise, skip to step 4.
a. Check to make sure the bender is on a level
surface and the shoe will not slide off after it is
unlocked from the bender. If the bender is not on
a level surface, skip to step 4.
b. Check that the spoke with the arrow is at the
9 o'clock position, as shown below.
c. While pulling the lock pin, slide the shoe 1" away
from the sprocket so the drive bolts clear the
sprocket.
Arrow
31
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070
Publicidad
