Descargar Imprimir esta página

RS Pro RSiLDM-150H Manual De Instrucciones página 4

Medidor de distancia por láser

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

Laser Distance Meter/ English
3. Initial Operation and Setting
Switching On and Off
Switches on the instrument and laser.
Hold down the button longer to switch off the instrument.
The instrument switches off automatically after three minutes of inactivity.
Clear Button
The last action is cancelled or the data display is cleared.
If in History storage mode, by pressing the Storage and Clear button
simultaneously, you will clear all storage data in the memory.
Reference Level Setting (See "Figure D")
The default reference setting is taken from the rear of the instrument.
Press this button to take the selection from the front edge , A special beep
sounds whenever the reference setting is changed. After a re-startup the reference
returns automatically to the default setting (rear reference).
Figure D
Using the Tripod reference
The reference must be appropriately adjusted in order to be able to take correct
measurements with a tripod. You can switch the reference on the tripod on or off
by Holding down the reference button.
Multifunctional end piece
The instrument can be adapted for the following measuring situations See figure (E).
For measurements from an edge, fold out the positioning bracket until it first locks
in place.
For measurements from a corner, open the positioning bracket until it locks in
place, then push the positioning bracket lightly to the right to fold it out fully.
See figure (F).
4
Figure E
Figure F
Display Illumination
Pressing the button illumination/ UNITS button of the display can be switched
on or off, user can trigger the function when he/ she is in darkness situation.
Distance Unit Setting For Instrument
Hold down the button longer to change the next type of unit.
The following unit can be set:
Distance
Area
1
0.000m
0.000m
2
0.0in
0.000ft
3
0 1/16in
0.000ft
4
0.000ft
0.000ft
5
0'00'' 1/16
0.000ft
4. Measuring
Single Distance Measurement
Press to activate the laser.
Press again to trigger the distance measurement, The measured value is displayed
immediately.
Laser Distance Meter/ English
Volume
2
3
0.000m
2
3
0.000ft
2
3
0.000ft
2
3
0.000ft
2
3
0.000ft
5

Publicidad

loading

Este manual también es adecuado para:

126-8822