Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATION
TO USE WHEEL
LOCKOUT
PIN
•
The left hand wheel issecured to the axle with a klick
pin (See Fig., 12A), This unit was shipped with this
klick pin in the locked (through wheel hole) position
•
Forease of maneuverability in light snowconditions,
disconnect the klick pin fromthe wheel locked position
and push into the single wheel drive (unFockedaxle
hole only) position (See Fig, 12B)
•
Make sure that the klick pin is in the single wheel
drive position of the axle only and not through the
locked position
BEFORE
STARTING
THE ENGINE
•
If the snow thrower must be moved without the aid of
the engine, it is easier to putlthe snow thrower by the
handles rather than pushing
II
Before you service or start the engine, familiarize
yourself
with the snow thrower,
Be sure you
understand the function and location of all controls
NOTE: Check tension of clutch cables before starting the
engine (See To Adjust The Control Cables paragraph on
page 19),
•
Be sure that all fasteners are tight
•
Make sure the height adjust skids are properly
adjusted (See To Adjust Skid Height paragraph on
page 18),
•
Check tire pressure (14 to 17 pounds) See side of
tirefor maximum inflation Do not exceed maximum
pressure
FILL OIL:
This snow thrower was shipped with a container of
5W30 oil This oil must be added to tile engine before
operating
Remove the oil fill cap!dipstick and fill the
crankcase to FULL line on dipstick (21 ounces) (See Fig
14)
NOTE: Engine may already contain some residual
oil Check frequently when filling the crankcase, Do
not over.fill
Tightenthe fill cap/dipstick securely each time you check
the oil level
NOTE: Oil must be changed after the first 2 hours of
operation to extend engine life
For extreme cord operating conditions of 0°F and below,
use a partial synthetic 0W30 motor oil for easier starting.
FILL GAS:
Fill the fuel tank with clean, fresh, unleaded grade
automotive gasoline Be sure that the container you pour
the gasoline from is clean and free from rust or other
foreign particles, Never use gasoline that may be stale
from long periods of storage in the container
12
KLICK PIN
LOCKED
POSITION
2-WHEEL
DRIVE
FIG. 12A
KUCK PIN
UNLOCKED
POSITION
SINGLE WHEEL DRIVE
FIG+ 12B
OIL FILL CA'PID|PSTICK
NOTE: OIL LEVEL MUST
BE BETWEEN FULL
AND ADD MARK
FIG.13
WARNING: Experience indicates that alcohol blended
fuels (called gasohot or those using ethanol or methanol)
can attract moisture which leads to separation and forma-
tion of acids during storage the fuel syslem of an engine
while in storage Acidic gas carl damage the fuel system
of an engine while in storage,
To avoid engine problems, the fuel system should be
emptied before storage for 30 days or longer, Start the
engine and let it run until the fuel lines and carburetor are
empty Use the carburetor bowl drain to empty residual
gasoline from the float chamber (Fig, 37, page 25) Use
fresh fuel next season
(See Storage instructions on
page 25 for additional information,)
Never use engine or carburetor cleaner products in the
fuel tank or permanent damage may occur
Publicidad
