Publicidad
Idiomas disponibles
Idiomas disponibles
TO REPLACE
BELTS
The drive belts on this snow thrower are of special
construction and should be replaced with original
equipment belts available from your' nearest Sears Store
or Service Center.
You will need the assistance of a second person while
replacing the belts,
Drain the gasoline from the fuel tank by removing the fuel
line.. Drain the gas and reinstall the fuel line.
CAUTION: DRAIN THE GASOLINE OUT- 1
DOORS, AWAY FROM FIRE OR FLAME.
I
AUGER
DRIVE
BELT
If your snow thrower will not discharge snow, and the
auger drive belt is damaged, replace it as follows:
•
Disconnect the spark plug wire._
•
Remove the belt cover (See Fig 27)
®
Loosen the belt guides (See Fig 28) and pull away
from the engine drive pulley
®
Loosen the nut on the auger idler pulley (See Fig 28)
and pull idler pulley away from the belt
•
Remove belt from engine drive pulley
•
Remove top two bolts securing auger housing to
motor mount frame. Loosen bottom two bolts, (See
Fig. 30, page 21).
•
Auger housing and motor mount frame will separate,
hinged by bottom two bolts.
•
Remove brake arm from housing Do not remove
spring
•
Remove old belt from the auger drive pulley.
•
Install new replacement belt of the same type onto the
auger pulley.
•
Reinstall brake arm into housing Ensure brake arm is
fully inserted into housing and brake pad is riding in
pulley groove.
•
Position belt onto engine drive pulley°
® Adjust the augerdrive belt (see ToAdjustAuger Drive
Belt paragraph on page 19).
•
Adjust the belt guides (see ToAdjust The Belt Guides
paragraph on page 21)
®
Replace top two bolts Re-tighten bottom two bolts
•
Reinstall the belt cover,
•
Checkthe clutch control cable adjustment (see page
19).
®
Reconnect the spark plug wire.
TRACTION
DRIVE
BELT
(See Fig. 28)
If your snow thrower will not move forward, check the
traction drive belt for wear, (Check other causes also in
the Trouble Shooting Points section.) 1Ithe traction drive
belt needs to be replaced, proceed as follows:
0
O
O
0
O
O
O
0
O
O
O
O
O
0
@
BELT
COVER
/
5/8 INCH
X 112 INCH SELF
TAPPING SCREW
FIG. 27
Hll
j
iji
TRACTION DRIVE
TRACTION DRIVE BELT
BELT GUIDE
DRIVE
BELT
BELT GUIDE
(Right Hand)
TRACTION DRIVE
IDLER PULLEY
DRIVE
PULLEY
IDLER
PULLEY
FIGo 28
Disconnect the spark plug wire.
Remove the belt cover
Loosen belt guides and pull guides away from the
engine drive pulley.
Loosen nut on auger idler and pull auger idler pulley
away from belt.
Remove auger drive belt from engine pulley
Pull the traction drive belt idler pulley away fromthe
drive belt.
Remove drive belt.,
Position new replacement belt ol the same type onto
traction pulley.
Pull idler pulley away from belt, allowing belt to be
positioned onto engine pulley
Release idler pulley Ensure idler pulley is property
engaged with belt.
Reinstall auger drive belt on engine
Adjust belt guides and tighten the mounting screws
(see To Adiust The Belt Guides paragraph on page
2f).
Readjust auger idler to adjust beet.See page 19
Reinstall the belt cover.
Reconnect the spark plug wire
2O
Publicidad
