Publicidad
Idiomas disponibles
Idiomas disponibles
SELECTION OF AUDIO/VIDEO
SOURCE
1
/
r'
1 Select the program source.
Press one of the function
buttons
or the TAPE MONITOR
button.
Tape
TAPE"MONITOR
Radio
TUNER
Record
PHONO
LD or Cable TV
VIDEO 2
MD or DVD
VIDEO
1/5.1 CH
The function
buttons to be pressed
(except PHONO) depend
on the equipment
connected
to the input terminals
on the
rear panel of the unit.
m
When using a turntable
with a built-in equalizer
amplifier,
set the
switch
of the equalizer
amplifier
to off. See the instructions
of
the turntable
for further information.
2 Start the selected program source.
3 Adjust the sound.
About the video source to the monitor or TV
I
Selected
VIDEO
source
V1 : VIDEO
1, V2: VIDEb
2, V3: VIDEO 3
The selected
video source
is indicated
on the display
and the
video signal through
the MONITOR
VIDEO
OUT jack is output
on the TV.
9
ENGLISH
To change
a displayed
name for the VIDEO 1/5.1 CH
button and VIDEO 2 button
Wtien
the
VIDEO
1/5.1
CH button
is pressed,
VIDEO
1 is '
displayed
initially.
It can be changed
tO
DVD
or
MD.
With the power on, press the POWER button while pressing
the
VIDEO
1/5.1 CH button.
This VIDEO
1/5.1 CH button
also works
as the 5.1 CH (5.1
INPUT)
function
switch.
While
the selected
function
name
(VIDEO
1, DVD or MD) for the VIDEO
1/5..1 CH button
is
displayed,
press the button again. The function name will change
to "5.1 CH" and the source connected
to the 5.1 INPUT terminals
is selected.
To resume,
press the button again so that the selected
function
name is displayed.
The displayed
name for VIDEO
2 button
can be changed
to
~
VIDEO 2, LD orTV
with the power on, press the POWER button
while pressing
the VIDEO 2 button.
To adjust the sound level of the connected source
The input sensitivity
level of each function
(except the TUNER
and 5.1 CH functions)
can be adjusted.
When the sound level of the connected
source is higher or lower
'
than that of the TUNER,
adjust it as follows.
,,
1 Select the function to be adjusted.
Press the function
button accordingly
and play the source.
2 Press the
UPA
or DOWNV
button repeatedly.
The level can be adjusted
between
-6dB (MIN) and +8dB (MAX)
in 2dB steps. Adjust the level so that the sound is output at the
same level as the TUNER.
m
The input sensitivity
level of the TUNER
or 5.1 CH function
cannot be adjusted.
That of the TAPE MONITOR
cannot be adjusted
either.
Even
if the TAPE
MONITOR
is selected
and the TAPE
MONITOR
indicator
turns red, pressing
the UPA or DOWNT
button will change
the level of the function
displayed
on the
window.
.,
Publicidad
