PowerA LUMECTRA 1522807-01 Manual De Usuario página 7

ALL ZONE ADJUSTMENTS
Similar to the individual zone adjustments, it is also possible to edit all zones at once
with the following button commands:
Button: Change the lighting color when in "Solid" or "Breathing" mode for all zones .
Each press will toggle through the 24 color options .
Button: Change the lighting mode for all zones . Each press will toggle through the 3 options .
Button: Increase the brightness for all zones .
Button: Decrease the brightness for all zones .
Button: Change the speed setting for all zones in "Breathing" or "Cycle" mode simultaneously .
Each press will toggle through the 3 options .
NOTE: Using the all-zone button commands will override individual zone settings .
UNDO LIGHTING EDITS
While in Lumectra program mode, it is possible to undo the changes made by double-pressing the LEDS button
( ) . This will revert the controller to the last saved Lumectra settings .
CHANGE TO LAST SAVED SETTINGS
The controller saves the 2 most recently saved Lumectra settings . To swap between them, double press the LEDS
button ( ) when in standard mode .
7
ADDITIONAL LUMECTRA FEATURES
BATTERY SAVING MODE
By default, the controller will turn the Lumectra lighting off after 5 minutes of inactivity to extend the battery life
of the controller. It is possible to disable this mode if preferred.
1 . Enter Lumectra program mode by holding the LEDS button for 2 seconds .
• Zone 1 will flash 3 times to indicate the controller is in Lumectra program mode .
2 . Press in the Left Stick for 2 seconds to disable battery saving mode, or press in the Right Stick for 2 seconds
to enable battery saving mode .
• All zones will flash 2 times to indicate battery saving mode has been disabled .
• All zones will flash 3 times to indicate battery saving mode is enabled .
3 . Exit Lumectra program mode to save this setting change by holding the LEDS button for 2 seconds .
• All zones will flash 3 times to indicate the settings have been saved and the controller is now out of
Lumectra program mode .
NOTE: Disabling this mode will deplete the battery charge more quickly .
DISPLAY MODE
Display Mode allows you to edit and turn on the Lumectra lighting without needing the controller to be paired to
the Nintendo Switch system . To activate display mode, press the LEDS button once when the controller is not
connected to turn on the lighting and again to turn them off . Follow the instructions in the previous sections to
edit the Lumectra settings .
NOTE:
• Plugging in the provided cable will allow the lights to stay on until the LEDS button is pressed again.
• If the controller is in battery saving mode, the lighting will turn off after 5 minutes.
• If battery saving mode is disabled, the lighting will stay on until manually turned off.
• It is recommended to use this mode with the cable plugged in to ensure the controller is charged and ready to go
when it is time to play.