Remington RM1215U Manual Para El Usuario página 16

REPLACING SAW CHAIN
Repk_ce dlain when cutters are too worn to shaq_en or
when chain breaks. Only use replacement chain noted in
this manual. Always include new drive sprocket when
replacing chain. This will maintain proper driving of
chain. Note: For proper chain and drive sprocket,
see Ru)lacemeut Parts and Accessories.
STORAGE
If storingsaw formole them30 &_ys, t bHowstepsbelow.
1. Drain oil tank.
2. Remove and clean guide bar and chain. Clean
guide bar and chain by soaking in petroleum
based solvent or mild soap and water mixture.
3. Dry guide bar and chain.
4. Place chain in container filled with oil. This will
prevent rust.
5. Wipe a thin coaing of all over stOhce of guide bar.
6. Wipe offoutside of sawN_dy.Do this with soft cloth
dampened with a mild soap and water mixture.
7. Store chain saw
• in a high or locked place, out of children's roach
• in a dry place
• in a cguryingcase or with scabbgu'd over guide bar
REPLACEMENT PARTS AND
ACCESSORIES
'_ WARNING: Use only replacement
parts and accessories described in this
manual. Use of other parts or accessories
could damage saw or injure operator.
For original repk_cement parts and accessories, call
1-866-206-2707 (in Canada call 1-877-696-5533)
or visit www.remingtonpowertools.com.
REPAIR SERVICE
Note: Only use original replacement parts. This will
protect your warranty coverage for parts replaced
under warranty.
For service, please call the Customer Support
Department tuobtain a list of authorized service
dealers near you. Service on this unit, both within
and after the warranty period, should only be
performed by an authorized and approved service
dealer.
Call 1-866-206-2707 (in Canada call 1-877-696-
5533) or visit www.remingtonpowertools.com.
16