Publicidad
Idiomas disponibles
Idiomas disponibles
Tempermre
Advanced Temperature
Control (se eot Models)
FREEZER
•
8_
_4_ ¸
00
REFRIG_R:ATOR
The control is located at the top front of the fresh food compartment.
@
Initial
Tempe_ture
Se_ing
F
@
Temperatures
are preset at the facto_
at 38 °
(3 C}
in the fresh food compartment
and 0° F (q7 ° C} in the
freezer cornpartmenL
Adjusting
the Control
24 hours after adding foo& you may decide that one
or both compartments
should be colder or warmer.
If
so, adjust the control as indicated
in the Temperature
Control Guide below.
- The first touch of the (£-, or :.?:'2pads shows the
current temperature
setting.
, The display will show the new setting for
approximately
three seconds, and then return to the
actual temperature
currently within that
compartment
• Do not change either control more than one degree
at a time.
Allow temperature
to stabilize for 24 hours
before making a new temperature
adiustmenL
Temperature
Control Guide
Refrigerator
too cold
Set the Refrigerator
control
to next higher number by
. pressing the _;_i) pa&
Refrigerator
too
Set the Refrigerator
control
warm
to next lower number by
Freezer too cold
Freezer too warm
Turn refrigerator
OFF
pressing the _v) pad.
Set the Freezer control to
next higher number by
pressing the (_) pad.
Set the Freezer control to
next lower number by
pressing tt_e (v) pad.
Press the Freezer (_i
pad
until OFF appears in the
display° Press either the
Freezer or Refrigerator
_*Z_)
pad to turn back on.
Quick C_bes
When activated, Quick Cubes reduces tt3e
freezer temperature
to the optimum
setting for
24 hours in order to produce more ice,
Important:
When the Quick Cubes feature is in
........
(" "
operation, the _,_ and <vi pads for the freezer control
will not operate.
Reset Filter [select
models)
•
Q
When a water filter has been installed in the
refrigerator,
the yellow Order light will illuminate
when g0 percent of the volume of water for
which the filter is rated has passed through
the
filter OR 11 months have elapsed since the filter has
been instafled.
The red Replace light will illuminate
when the rated
volume of water has passed through
the filter OR 12
months have elapsed since the filter was installed.
A
new filter should be installed immediately
when the
Replace light is illuminated.
After replacing the filter, press and hold the Reset
Filter pad for three ([3] seconds.
The Order and
Replace lights will go off.
Vacation
Mode
[select
models)
The Vacation Mode feature causes the freezer to
_;,_
defrost less frequently,
consen4ng energy: The
Vacation Mode indicator
light will illuminate when the
feature is activated.
To deactivate,
press the Vacation
Mode
pad again OR open either door. The indicator
light will go out.
Notes:
, Door openings will not deactivate Vacation Mode
for approximately
one hour aRer activation.
if vacationing
for more than a few days, see the
Prepanng for Vacation section, page 2&
_3
Publicidad
