Descargar Imprimir esta página

Kenmore ELITE 596.76052700 Guía De Uso Y Cuidado página 25

Refrigerador con congelador inferior

Publicidad

Idiomas disponibles

Idiomas disponibles

I;leanln
Preparing for Vacation
If there is any possibility that the temperature
can
drop below freezing where the refrigerator
is
located, the water supply system (including
the
water tank and the water valve) must be drained by
a qualified servicer.
For short vacations or absences [three months
or less):
1. Remove all perishables.
2. If no one will be checking
in on the refrigerator
during your absence, remove all frozen items also.
3. Since your refrigerator
has an automatic
ice maker:
• Shut off the water supply to the ice maker at
least one day ahead of time.
* After the last load of ice drops, raise the wire
shut off arm to the OFF position.
Empty the ice bin.
4. If the room temperature
will drop below 55 ° F
(13° C), follow the instructions
for longer absences.
For long vacations,
absences
[more
than three
months)
OR if the room temperature
will drop
below
55 ° F (13 ° C):
1. Remove food.
2. Since your refrigerator
has an automatic
ice maker:
Shut off the water supply to the ice maker at
least one day ahead of time.
* After the last load of ice drops, raise the wire
shut off arm to the OFF position.
• Empty the ice bin.
3. Since your refrigerator
has a dispenser system with
water filter, remove the water filter cartridge
and
install the filter bypass. Dispose of the used
cartridge.
4. Turn the Freezer control to OFF.
5. Unplug the refrigerator.
6. Thoroughly
clean the interior of both compartments
with a baking soda solution and a clean, soft cloth
(four tablespoons
of baking soda in one quart of
warm water).
7. Dry thoroughly.
8. Leave the doors open to prevent the formation
of
mold and mildew.
Upon your return:
After a short vacation
or absence:
For models with automatic
ice makers or dispensers:
Reconnect the water supply and turn on supply valve
(see pages 10-11).
* Monitor water connection
for 24 hours and correct
leaks if necessary.
. Run 10-15 glasses of water from the dispenser to
flush out the system.
. Restart the ice maker by lowering the ice maker arm.
* Discard at least the first three ice harvests.
After a long vacation
or absence:
. Reconnect the water supply and turn on supply valve
(see pages 10-11).
* Plug the refrigerator
back in and reset controls
(see
page 13-14).
. Monitor water connection
for 24 hours and correct
leaks, if necessary.
For dispenser models, run water through the dispenser
for at least three minutes with the filter bypass in
place, then install water filter (see page 18).
* After installing the water filter, run water through
the
dispenser continuously
for at least two minutes, or
until water runs steady.
Initially you may notice a
one to two minute delay in water dispersal as the
internal tanks fills.
* Restart the ice maker by lowering the ice maker arm.
. Discard ice produced within the first 12 hours (at
least the first three harvests).
Preparing to Move
, Follow the instructions
for long vacations/absences,
through
step 7.
Secure all loose items such as shelves and drawers
by taping them securely in place to prevent damage.
* Tape the doors shut.
. Use an appliance
dolly when moving the refrigerator.
ALWAYS truck the refrigerator
from its side or back
- NEVER from its front.
. Be sure the refrigerator
stays in an upright
position
during moving.
25

Publicidad

loading