Kingfisher Hollis ST1008WUPR Manual Del Usuario página 3

EN Safety
EN Safety
Warning
0% 100%
IMPORTANT! Do not use
with a dimmer switch.
IMPORTANT - Retain for future
reference: read carefully.
• These instructions are for your safety.
Please read through them thoroughly
prior to installation and retain them for
future reference.
• All fittings must be installed by a competent
person in accordance with local regulations
(IET wiring regulation BS7671).
• Check the pack and make sure you have all
of the parts listed.
• Remove all packaging, wrap etc. from the
product.
• Decide on the appropriate location for
your product.
CAUTION: IP44 is guaranteed when
the product is properly installed and
sealed.
• Always avoid the product to be located at
corrosive environment.
• Always refer to the installation drawing for
the orientation of the product.
• The product must be securely fixed to the
mounting surface using the screws and
wall plugs supplied. The screws and wall
plugs supplied are suitable for "masonry"
only. Other fixings not supplied and must be
purchased.
• Take care not to drill into any pipes or
mains cables beneath the surface during
mounting holes preparation.
216583_s8_s4_5059340247434_No Name_A5_IM-V04.indb 2 216583_s8_s4_5059340247434_No Name_A5_IM-V04.indb 2
IMPORTANT: The fixing point(s)
selected must be capable of supporting
the full weight of the light fitting.
• We recommend connecting this product
to an external / wall switch in order to
deactivate the motion detection function
if necessary.
• Wiring diagram is for reference only. Always
refer to the terminal marking for wiring.
Ensure that all electrical connections are
tight and that no loose strands are left out of
the terminal block.
• Never put anything on the product or hang
anything on any part of this product.
• Never use the terminal cables to bear the
product weight.
• When the product does not light after
installation:
> Ensure there is no electricity failure.
> Ensure all the connections are secured.
• If you have any doubt about installation /
use of this product, consult a qualified
electrician.
• Always disconnect the product from mains
at least 10 minutes allowing to cool down
before any maintenance or adjustment.
• It is recommended to have a regular
schedule of care and maintenance to keep
the surface condition well.
02
05-10-2021 16:19:36 05-10-2021 16:19:36