Kingfisher Hollis ST1008WUPR Manual Del Usuario página 6

EN Safety
Symptom
The light comes
on for no apparent
reason.
Coverage area of
sensor is poor.
The lights stay on
continuously
The lights flash on
and off
216583_s8_s4_5059340247434_No Name_A5_IM-V04.indb 5 216583_s8_s4_5059340247434_No Name_A5_IM-V04.indb 5
Possible Cause
The product is wired through a dimmer
or timer
The "SENS" control is set too high
Wind is moving trees and bushes in the
detection zone
Cars in the street are being detected
Reflective objects (such as swimming
pool) in the coverage area.
Sunlight is falling onto the lens
Unit is sensing motion in the detection
zone.
Choose a suitable location for installing
the product, away from trees, hot
ventilator dusts, street lighting and
traffic, which may interfere with its
operation
The product is wired through a dimmer
or timer
Ensure the unit is not positioned to
detect unwanted objects e.g. cars /
people using roads / footpaths next
to your property. Occasionally, wind
may activate the sensor. (Sometimes
passages between buildings etc. can
cause a "wind tunnel" effect.)
The unit is operated in the mode of the
motion sensor being deactivated.
Heat or light from the bulbs may be
turning the sensor on and off
Sensor is sensing reflected light from
the light fixture.
Solution
Do not use a dimmer or timer to
control the product. Repelace the
dimmer or timer with a standard on/
off wall switch
Decrease the "SENS" setting
Relocate the unit
Relocate the unit
Relocate the unit
Mount unit in a sheltered place
Test the motion sensor by covering up
the front curved lens with cardboard
to block the view. If the light turns off
then something in the detection zone
is triggering the sensor. Relocate
the unit or change the sensitivity
(distance) of the sensor.
Relocate the unit
Do not use a dimmer or timer to
control the product. Repelace the
dimmer or timer with a standard on/
off wall switch
Relocate the unit
To activate the motion sensor
Relocate the unit, away from the light
source.
1. Change position of light head aim light
away from the reflecting surfaces.
2. Relocate the unit to a different
location where it no longer causes
reflected light.
05
05-10-2021 16:19:37 05-10-2021 16:19:37