Publicidad
Idiomas disponibles
Idiomas disponibles
Before you clean the unit, make sure you have turned it off by setting its external switch to OFF. Do not use
insecticides, solvents or aggressive detergents: these can damage the unit's painted and plastic parts.
IF THE WATER COMES OUT COLD
Disconnect the appliance from the power supply and have the following checked:
- the presence of voltage on the power terminal block (Fig. 7, Rif. M);
- the circuit board;
- the heating elements;
- inspect the bypass pipe (Fig. 5, Rif. X);
- the sensor holder rods (Fig. 7, Rif. K)
IF THE WATER COMES OUT BOILING HOT (STEAM IN THE TAPS)
Disconnect the appliance from the electricity supply and have the following checked:
- the circuit board
- the amount of scale on the boiler and components;
- the sensor holder rods (Fig. 7, Rif. K)
THE HOT WATER DELIVERY IS INSUFFICIENT
Disconnect the appliance from the electricity supply and have the following checked:
- the pressure of the water mains;
- the condition of the deflector on the cold water intake pipe;
- the condition of the hot water pipe;
- the electrical components
WATER TRICKLING FROM THE PRESSURE SAFETY DEVICE
During the healing phase, some water may trickle from the tap. This is normal. To prevent the water trickling, a
suitable expansion vessel must be installed on the flow system. If the trickling continues even after the healing
phase, have the following checked:
- device calibration;
- the pressure of the water mains.
Caution: Never obstruct the appliance outletl
IF THE PROBLEM PERSISTS, NEVER ATTEMPT TO REPAIR THE APPLIANCE YOURSELF, BUT ALWAYS
CONTACT QUALIFIED TECHNICIAN.
The indicated data and specifications are not binding; the manufacturer reserves the right to modify them
at his own discretion notification or replacement.
This product conforms to Directive WEEE 2012/19/EU.
The symbol of the crossed waste paper basket on the appliance and its packaging indicates that
the product must be scrapped separately from other waste at the end of its service life. The user
must therefore hand the equipment over to a sorted waste disposal facility for electro-technical and
electronic equipment at the end of its service life.
Alternatively, he may return the equipment to the retailer at the time of purchase of a new equivalent type of
appliance. Electronic equipment of size less than 25 cm can be handed over to any electronics equipment
retailer whose sales area is at least 400 m
new product.
USEFUL INFORMATION
2
for disposal free of charge and without any obligation to purchase
EN / 23
Publicidad
