Publicidad
Idiomas disponibles
Idiomas disponibles
4. Features
flexible PCB (white)
contains 150 high brightness LEDs (type 5050)
RGB controller with different programs: 44 keys
fixed colour
o
animated program
o
controlled through infrared remote (incl.)
can be cut every 3 LEDs (10 cm)
power supply included
self-adhesive
5. Operation
Refer to the illustrations on page 2 of this manual.
Installation
1.
Mount the LED strip in the desired location. The LED strip can be cut
every 10 cm (see [A]). The cut ends must be protected to avoid short-
circuits.
2.
Connect the LED strip to the controller [B2] (connecting tools not
included). Make sure to connect matching wire colours. Do not short-
circuit any wires.
3.
Connect the included power adaptor to the controller [B1]. Plug the
other end into the mains.
Use
1.
Aim the remote control [C] towards the IR LED [B3] of the controller
to control the output of the LED strip.
2.
Switch the LED strip on with the ON button on the remote control. To
switch it off again, press the OFF button.
3.
Select the desired light output colour by pressing the corresponding
colour button on the remote control.
4.
To increase or decrease output brightness, press the
5.
Press the effect buttons to generate different effects:
button
FLASH
STROBE
FADE
SMOOTH
6. Battery
Refer to illustration D on page 2 of this manual.
The remote control uses 1 battery type 3 V lithium CR2025 (included).
V. 02 – 21/10/2015
LEDS15RGB/LEDS18RGB/LEDS19RGB
effect
red, green, blue colours switching, fast
red, green, blue colours switching, slow
colours fading, fast
colours fading, slow
4
or
button.
©Velleman nv
Publicidad
