GAPOSA EMITTO QCT1 Manual Del Usuario página 5

LIMIT SWITCH SETUP
(ATTENTION: Just for motors with elec-
tronic limit switch).
ALWAYS SET THE UP LIMIT SWITCH
FIRST.
1. Push PROG-FC till the motor makes
a brief movement in both direction, then
press the UP button.
2. Be ready to stop the motor (by pressing
STOP) when it reaches the desired limit
switch position or wait till the motor stops
automatically on the limit positions of the
shutter/awning. In both cases the limit
switch memorizes the position where the
motor stops.
3. For an accurate setup press PROG-FC
while the motor is turning. The motor will
move slowly and jerkily towards the limit
switch position.
4. Push DOWN and be ready to stop
the motor (by pressing STOP) when the
desired limit switch position has been
reached.
5. For an accurate setup press PROG-FC
while the motor is turning. The motor will
move slowly and jerkily towards the DOWN
limit switch position.
INTERMEDIATE POSITION SETUP
Stop the shutter/awning in the desired
intermediate position, then press simul-
taneously the UP and DOWN buttons until
the motor makes a brief movement in
both directions. The intermediate position
has been setup.
RECALLING THE INTERMEDIATE POSI-
TION
Keep the STOP button pressed at least for
3 seconds: the shutter/awning will move
till it reaches the intermediate position.
ERASING THE INTERMEDIATE POSITION
Press simultaneously the UP and DOWN
buttons until the motor makes a brief
movement in both directions.
CHANNEL MANAGEMENT (QCT6)
The QCT6 transmitter has 6 channels.
By pressing SELECTION, you pass through
the channels sequentially in this order:
- last channel/
group used
- channel 1
- channel 2
- channel 3
- ...
- all channels
- channel 6
- channel 5
- channel 4
Once the desired channel selected, you
can proceed to activate the correspon-
ding motor by using UP, STOP and DOWN
buttons.
Moreover, you can also memorize up to 8
combinations of groups of channels.
CREATING A GROUP OF CHANNELS
1. Select by UP / DOWN the first channel
to which you will add the rest.
2. Press and hold SELECTION until the
next channel's LED starts to flash.
3. By SELECTION select the channel to be
added.
4. To confirm the channel to be added hold
SELECTION.
The channel LED will stop flashing and
remain lit then the next channel starts to
flash.
Continue this sequence until all the desi-
red channels are added.
To memorize the group press STOP or
wait that the LEDs turn off.
SELECTING A MEMORIZED GROUP OF
CHANNELS
With all the LEDs off, press SELECTION
and hold: the channels of the last group
created will turn on.
By pressing SELECTION again you pass
through the memorized groups.
By selecting the desired group you can
activate the motors by UP, STOP, DOWN.
IMPORTANT: you can select the 8 last
memorized combinations.
The memorization of further groups will
require to delete the already memorized
channels starting from the oldest.
BATTERY SUBSTITUTION (Fig. 4)
1. Remove the screw on the back
2. Remove the cover.
3. Remove the old battery and insert the
new battery respecting the correct polarity
WARNING: Batteries contain pollutant
elements, must be disposed of in accor-
dance with environmental regulations.
Transmitter contains pollutant elements
too; follow the same procedure to dispo-
se. Should the batteries lose electrolytic
substances, please replace them imme-
diately avoiding with care any contact with
such substances.