Descargar Imprimir esta página

Argo APOLLO 12HP Instrucciones De Uso página 4

Acondicionador de aire sin unidad exterior

Publicidad

USING THE REMOTE CONTROL UNIT
EN
HOW TO INSTALL BATTERIES
Remove the lid in the rear part of the remote control
unit: gently press it with your finger, pushing it out in
the direction of the arrow.
Insert two AAA alkaline batteries of 1,5 V-DC making
sure that point in the direction marked in the battery
compartment.
Remote controller is now ready for operation.
HOW TO REMOVE BATTERIES
Remove the lid.
Press the battery toward the negative end and lift it out
by its positive end.
Remove the other battery in the same way.
NOTES
The batteries last about six months. Depending on how
much you use the remote control unit.
Remove the batteries if you do not use the remote
control unit for more than one month.
Replace the batteries when the remote control unit
lamp fails to light, or when the air conditioner does not
receive the remote control unit signals.
The batteries of the remote control contain polluted
substances, exhausted batteries must be disposed
according to the laws in force.
If there are curtains, doors or other objects that block
the signal from the remote control to the air condi-
tioner, the air conditioner will not be controlled by the
remote control.
Beware of any liquid fl owing into the remote control,
do not expose the remote control to direct sunlight, or
place it in extreme heat.
If other electronic devices affect the remote control,
please remove them.
You should replace the new battery at the same time,
do not use the old battery or different types of batter-
ies, otherwise it will cause the remote control malfunc-
tion.
If the reset occurs when the remote control button is
pressed, it indicates that the battery is low. Please re-
place the battery with a new one.
OPERATION WITH THE REMOTE CONTROL UNIT
When using the remote control unit, always point the
remote control unit directly at the air conditioner receiver.
HOW TO TURN ON OR OFF THE AIR CONDITIONER
Press the ON/OFF button on the remote control unit to turn
the air conditioner on or off. The standby LED will switch
off, indicating the unit is in operation and vice versa.
4

Publicidad

loading