Teka HBB 435 Manual Del Usuario página 17

Teka Hydroclean
This function makes it easy to remove grease
and other food debris that may have stuck to
the sides of the oven.
For easier cleaning, do not allow dirt to accu-
mulate. Clean the oven frequently.
pRoGRammING THE TEKa
HYDRoClEaN FUNCTIoN
®
WaRNING
Do not pour water into a hot oven as this can
damage the enamel of the oven.
Always run the cycle on a cold oven. The result
could be affected and the varnish damaged if it
is run when the oven is too hot.
First remove the trays and all accessories from
the oven interior, including the tray supports
and telescopic guide rails.
To do this, follow the instructions in the in-
stallation and maintenance guide accom-
panying the oven.
1. With the oven cold, spread a cloth out on
the bottom of the oven.
2. Gently pour 200 ml of water into the bottom
of the oven cavity.
function
®
INFoRmaTIoN
For best results, add a teaspoon of mild
washing up detergent to the glass of water
before pouring onto the cloth
3. Turn the control dial to position
4. Set the temperature to 90º C.
5. Programme a duration of 4 minutes on the
timer.
6. After 4 minutes, an alarm will sound and the
oven will stop heating.
7. Turn the control dial to position
8. Wait for about 20 minutes for the interior of
the oven to cool.
ImpoRTaNT
Do not open the oven until the cooling phase
is complete.
This is necessary for the Hydroclean® func-
tion to work properly.
9. Any traces of dirt and excess water can now
be removed from the oven with the damp
cloth.
The Hydroclean function takes place at a low
®
temperature. However, cooling times can vary
depending on the room temperature.
WaRNING
Before touching the inside surface of the
oven, make sure that it has cooled properly.
If a deeper clean is required after using the Hy-
droclean function, use neutral detergents and
®
non-abrasive sponges.
English
.
.
17
User's Guide